User manual AEG-ELECTROLUX EU1232I

[. . . ] Children should not be allowed to tamper with the controls or play with the appliance. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used. It is dangerous to alter the specifications or modify this appliance in any way. [. . . ] Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances, unless they are appr oved for this purpose by the manufacturer. 28 INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Instructions for totally built-in appliances Dimensions of the recess Height Depth Width 880 mm 550 mm 560 mm Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. ; best performance is obtained with ambient temperature between +16C and +32C (class N) or between +10C and +32C (class SN). The class of your appliance is shown on its rating plate. For building into kitchen units follow the special "Building-in" instructions given. The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. 50 mm Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by 6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The appliance must be earthed. D567 min. cm2 200 The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. Fig. 2 A Push appliance into the housing until stop strip (A) touches the kitchen unit. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. D022 Fig. 3 A Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. D265 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). 29 Fig. 7 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. D Fasten the appliance with 4 screws provided in the kit inC cluded with the apD020 pliance. Snap vent grille (C) and hinge cover (D) into position. Fig. 5 H 20m m D094 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. [. . . ] However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: pull out the plug from the wall socket or turn the thermostat knob to the setting; remove any stored food, wrap it in several layers of newspaper and put it in a cool place; leave the door open, and insert the plastic scraper in the appropriate seating at the bottom centre, placing a basin underneath to collect the defrost water; D068 Fig. 12 when defrosting is completed, dry the interior thoroughly; keep the scraper for future use; turn the thermostat knob back to the required setting or replace the plug in the power socket. After letting the appliance run for two or three hours on the quick-freeze setting, reload the previously removed food into the compartment. Important: A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. MAINTENANCE Unplug the appliance before carrying out any maintenance operation. [. . . ]