User manual AEG-ELECTROLUX EU2421C

[. . . ] INFO INSTALLATION AND INSTRUCTION MANUAL FREEZER EU 2421 C 2222 055-31/1 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 3 4 4 4 4 4 5 5 6 6 6 6 6 7 7 7 7 8 8 8 9 9 9 9 9 Installation . Positioning . Rear spacers. Electrical connection . Cleaning the interior . Changing the Opening Direction of the Door . Reversing the Quick-freezing Compartment Door . [. . . ] If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. 100 mm A 10 mm B 10 mm The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. NP007 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 4 Changing the Opening Direction of the Door Unplug the freezer before performing the following operations: Remove the ventilation grill (D-Fig. 2) by loosening the two fastening screws. Fig. 3 Take off the handle cover (see Fig. Remove the handle and refit it on the opposite side. Fig. 3a E F G F D268 G B0646 The holes that are not used are to be masked with the plastic plugs removed. If, after having reversed the door, it is not in line with the unit, the top hinge can be adjusted. To do this, use a 10 mm spanner as shown in Figure 3; slacken the nut, align the door by pushing it to the left or right, then re-tighten the nut. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. D Remove the door by sliding it out of the upper pin (AFig. Unscrew the pin and the washer (A+B-Fig. 3) and refit them on the opposite side. Fig. 4 C B A Reversing the Quick-freezing Compartment Door (Fig. 4) Unscrew the closing prong support (A). D427 Unscrew the two hinges (B) and remove the door. Turn the closing prong support and fix it to the other side of the Quick-freezing compartment. Reverse the door and the hinges and mount them on the other side of the compartment. Check to see that the door closes correctly. Fig. [. . . ] Make sure that all frozen food packages are intact; otherwise the food may have spoiled. Rules to Observe when Freezing Foods All products to be frozen must be fresh and of excellent quality. Each freezing package must be adjusted to the family's consumption quantity in order to be used just once. Small-sized freezing packages allow a more rapid and uniform freezing. Do not forget that once frozen foods have thawed out, they spoil rapidly. 7 If such packages present signs of swelling or humidity marks, this means that the food has not been conserved correctly, implying that the product has lost some of its original quality. [. . . ]