User manual AEG-ELECTROLUX EU6222

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. Ice lollies can cause frost burns if consumed straight from the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. [. . . ] The class of your appliance is shown on its rating plate. For building into kitchen units follow the special " Building-in" instructions given. Assembly instructions Fitting the decor panel (Fig. 1) Preliminary requirement: the overall dimensions of the decor panel must be 1-2 mm less than those of the door, with a maximum thickness of 4 mm. With the refrigerator door closed, unscrew the screws securing the removable side piece of the frame to the door. Remove this side piece and slide the decor panel into place, after having slackened the remaining frame screws; push the panel fully home and secure the frame to the door, including the side piece previously removed. Important It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent mod)fications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Fig. 1 36 Door reversal Right hand door opening Remove the upper and lower screws (1) and pivots (2) with the safety washer (4) on the left side (Fig. 2 2 Left hand door opening Remove the upper right screw and pivot. Straighten the safety washer (4) of the lower right hinge. Remove the screw (5) and the pivot (ó) (Fig. For safety reasons bend the washer located under the left hinge (Fig. Remove the right door stop hinge (3-Fig. 3 3 6 4 5 D562 Fitting the handle Holes for fitting the handle on the opposite side are provided, with fixing screws already in place. Fig. 4 6 4 5 D563 I nstructions for totally built-in appliances min. 200 cm Dimensions of the recess 2 50 mm Fig. 5 Height Depth Width 880 mm 550 mm 560 mm min. cm 200 2 The appliance's door has been locked in position for transport by means of pins on both sides. [. . . ] After two or three hours, reload the previously removed food into the compartment. Important A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. Fig. 8 D068 41 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorized technicians. Internal clearing Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry. External clearing Wash the outer body with lukewarm water and soap. [. . . ]