User manual AEG-ELECTROLUX EU6230T

[. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Installation There are working parts in this product which heat up. [. . . ] Do not use detergents or abrasive powders, as these will damage the finish. 40 Door reversibility 1 Fig. 2 2 Before starting work, unplug the appliance. Pull off the ventilation grille (D), which is a clip-on fit. Remove the bottom hinge (E) by unscrewing its two fixing screws. Unscrew pin (2) and screw it onto the opposite side. Refit the door. D303 3 4 E F F F D F Refit the bottom hinge on the opposite side using the two screws previously removed. Slide the hole cover (F) off the ventilation grille (D) and fit it on the opposite side. Refit the ventilation grille, clipping it into place. Unscrew the handle. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. 41 Building the appliance in under a worktop This appliance can also be built in under the worktop of your kitchen units. 2): remove screws which secure the top to the rear brackets and front hinges; move the top slightly to release it from the retainers and remove it; unscrew the screws securing the rear feet to the cabinet; remove the 3 mm shim from the feet and refit them; screw in the front feet to obtain the required height. Important For the appliance to function properly, an opening of at least 137 cm2 (Fig. A minimum clearance must also be provided between the condenser and the wall, as shown in the Fig. 4 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. 42 GB USE GB The freezer is marked with the symbol, which means that the compartment is suitable for freezing fresh food and for long-term storage of frozen food. Control panel (Fig. «SUPER» operating pilot lamp SUPER min max E D C A Starting-up and Temperature Regulation Insert the plug into the wall socket, the pilot light (C) will light up to show that the appliance is working. Turn knob (B) beyond the «O» position. To safely store frozen and deep-frozen foods, the inner temperature of the freezer must be at least ­18°C or colder. Therefore, we suggest you turn the knob (B) to a medium setting. The temperature inside the freezer is automatically adjusted to ensure safe storage of the food. However if the appliance works in unfavourable room conditions such as poor ventilation, high ambient temperature and frequent door openings, it might be necessary to select a more suitable setting. [. . . ] Important A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. Ice cube trays The appliance includes one tray for producing ice cubes. This tray should be filled with drinkable water and repositioned inside the compartment. Do not use metal tools to remove the tray when it is stuck-frozen inside the compartment. 45 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. GB Periods of non-operation When the appliance is not in use for long periods, take the following precautions: remove the plug from the wall socket; remove all food; defrost and clean the interior and all accessories; Periodic cleaning Never use metal objects for cleaning your appliance as it may get damaged. [. . . ]