User manual AEG-ELECTROLUX EU6921C

[. . . ] INFO MUKÖDÉSI ÉS HASZNÁ INSTRUKCJA NÁVOD NA INSTALA RUKOVODSTVO PO È INSTALLATION AND INST LATI UTASÍTÁS OBSLUGI CI A POUZITÍ KSPLUATACII RUCTION MANUAL FAGYASZTÓSZEKRÉNY ZAMRAQARKA MRAZÁK MOROZILWNIK FREEZER EU 6921 C EU 6921 C EU 6921 C EU 6921 C EU 6921 C 2222 129-48 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 39 41 41 41 41 41 42 43 43 43 43 43 43 44 44 45 45 45 45 45 46 46 46 46 Installation . . Rear spacers. Power connection . Cleaning the appliance's interior . . Using your freezer The control panel . [. . . ] 2 Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +16°C and +32°C (class N) or between +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. For safety reasons, minimum ventilation must be as shown in Fig. 1: Appliance positioned under overhanging kitchen wall units (see Fig. Appliance positioned without overhanging kitchen units (see Fig. Attention: keep ventilation openings clear of obstruction. Two adjustable feet at the cabinet base allow accurate levelling of the appliance. Fig. 1 A 45¡ D039 Power connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 100 mm A 10 mm B 10 mm NP006 Cleaning the appliance's interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 41 Door reversal Before starting work, unplug the appliance. To reverse the opening direction of the door proceed as follows: remove the lower hinge (3), pin (1) and foot (2); unscrew the front left foot and screw it back in on the opposite side; remove the two screws which mask the holes for fixing the hinge from the front left hand side; reassemble the door; refit the lower hinge (turning it through 180°), the pin and the foot on the opposite side, as shown in the figure. Remove the handles, after having removed the screw cover and refit it on the opposite side. The holes that are not used must be masked with the plastic plugs removed. Attention After having reversed the opening direction of the door check that all the screws are properly tightened and that the magnetic seal adheres to the cabinet. [. . . ] 8, place underneath a basin to collect the defrost water. Fig. 8 Helpful hints Always check the preparation date indicated on the frozen foods you buy and respect the expiration time provided by the producer. Do not open the freezer door too often and leave it open only for the minimum time necessary. Unnecessary increases in temperature will notably reduce the duration of the frozen food conservation. [. . . ]