User manual AEG-ELECTROLUX EUC2901

[. . . ] Co n g é l a t e u r / G e f r i e r / F r e e z e r / V r i e s GEBRAUCHSANWEISUNG NOTICE D'UTILISATION INSTRUCTION BOOK GEBRUIKSAANWIJZING DE FR EUC2901 GB NL 818 21 19--03/5 Safety instructions GB Carefully read these instructions to learn how the appliance works and how to care for it. It will come in handy if you later sell the cabinet or give it to somebody else. These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. [. . . ] When cleaning the cabinet, use a mild washing-up detergent. Follow the advice in the section "Saving energy" The door gasket and coolant used in this cabinet will not harm the ozone layer. All parts in the packaging can be recycled. The cabinet has been designed for easy dismantling and subsequent recycling. Electrolux 818 21 19-03/5 · · · · · · Maintenance and Cleaning Removing the ventilation grille The ventilation grille can be removed, e. g. Make sure the door is open when removing the ventilation grille. Unsnap the upper edge of the grille by pulling outward/downward. Then pull the grille straight out to completely remove it. GB Cleaning Clean the cabinet at regular intervals. Don't use detergents, abrasive powders, high perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol when cleaning the product Disconnect the appliance from electricity supply. Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0, 5 litre water) Rinse and dry thoroughly. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. Wash the outer cabinet with warm soapy water. Remove the ventilation grille (see the section "Removing the ventilation grille") and vacuum-clean under the cabinet. Once or twice a year dust the condenser (black grille) and the compressor at the back of the appliance, with a brush or vacuum cleaner, as an accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. When moving the cabinet, lift it by the front edge to avoid scratching the floor. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. Remove the freezer drawers and place them on top of each other by turning every other drawer one half turn. Put insulating material around the drawers, e. g. The frozen products can also be packed closely together and be kept in a cold location, e. g. Defrosting can be accelerated by placing bowls with hot water (not boiling) inside the freezer. Loosen the drainage channel from its resting position and push in according to the illustration and place it in the bottom freezer drawer where water can collect. Carefully scrape off the ice when it starts to thaw. Do not use sharp objects as these may damage the interior. When all the ice has melted, clean and wipe the cabinet dry, then put the drainage channel back in place. [. . . ] If necessary adjust the feet using the adjustment spanner supplied. · there is good air circulation around the cabinet and that the air channels below and behind the cabinet are not blocked. The ventilation space above the cabinet must be at least 4 cm. The ventilation space can either be a) directly above the cabinet, or b) behind and above the top cupboard. [. . . ]