User manual AEG-ELECTROLUX EUN1273

[. . . ] freezer INSTRUCTION BOOKLET EUN 1273 2222 753-54 UK Important Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation · Check the appliance for transport damage. Under no circumstance should a damaged appliance be installed. [. . . ] To carry out complete defrosting proceed as follows: 1. Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. Turn the thermostat control knob to the «I» setting. Leave the door open and introduce the plastic scraper in the appropriate seating at the base of the cabinet as shown in the figure and place a basin underneath to collect the defrost water. Important A temperature rise of the frozen food packs during defrosting may shorten their storage life. Never use sharp metal tools to scrape off frost from the evaporator as you could damage the appliance beyond repair. Important In the event of a power failure causing the temperature within your freezer to rise, do not refreeze the food without checking its condition. The following guidelines should assist you: Ice-cream: once thawed should be discarded. Fruits & Vegetables: if soft should be cooked and used up. Breads & Cakes: can be re-frozen without danger. Shellfish: should be refrigerated and used up quickly. casseroles should be refrigerated and used up. Large Pieces of Meat: can be re-frozen providing there are still ice crystals remaining within them. Small Joints: should be cooked and can then be refrozen as cooked dishes. Chicken: should also be cooked and re-frozen as a cooked dish. D068 4. When defrosting is completed, dry the interior thoroughly. Turn the thermostat control knob to a medium setting and, after letting the appliance run for at least two hours in the «fast freeze» mode, replace the previously removed food into the compartments. 8 Maintenance and Cleaning Warning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Important This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0. 5 litre of water). NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING PRODUCTS OR WAX POLISHES, TO CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG SMELL. Once or twice a year remove the ventilation grille and dust the air channels at the base of the appliance with a brush or vacuum cleaner. You MUST ensure that the appliance is switched OFF. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. [. . . ] - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent amendments. Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of breakdown. BLUE D207 CORD CLAMP 14 13 AMP BROWN Building in Dimensions of the recess Height of housing Depth of housing Width of housing 540 mm 880 mm 550 mm 560 50 1 3 2 1 D022 2 1. Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2). PR0 It is necessary that the cabinet has a ventilation recess with the following dimensions: Depth 50 mm Width 540 mm 50 mm min. [. . . ]