User manual AEG-ELECTROLUX EUN6300

[. . . ] Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. [. . . ] For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. · · CONTENTS Warnings . . 25 Use - Cleaning the interior - Control panel - Operation - Temperature regulation - Fast freezing . . 27 Use - Storage of frozen food - Thawing - Ice-cube production - . . 28 Hints - Hints for freezing - Hints for storage of frozen food . . 29 Maintenance - Periodic cleaning - Periods of non-operation - Defrosting - . . 30 Customer service and spare parts - Technical information - Installation - Location - . . 31 Positioning - Instructions for totally built-in applinces . . 32 26 USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Control panel 0 6 5 3 4 1 2 A. Temperature alarm light Operation Insert the plug into the wall socket. The pilot light will light up, indicating that the appliance is in operation. To stop the appliance, turn the thermostat knob to position «0». Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob towards minimum number or reduced (colder) by rotating the knob towards maximum number. However, the exact setting should be chosen keeping in mina that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. To stop operation, simply turn the thermostat knob to position «0». Warning light Warning light (E) lights up when the temperature inside the freezer compartment has increased to a value which might endanger the long-term storage of food in the compartment. When the appliance is switched on for the first time or when food is placed in the compartment for freezing, it is normal for this light to remain on until the temperature has reached the level required for correct storage. Freezing fresh food The 4-star compartment is suitable for long term storage of commercially frozen food, and for freezing fresh food. Do not exceed the storage times shown by the manufacturer on the commercially frozen food packets. If the freezer has already been working for some time, press the N/S knob (D) at least 24 hours before introducing the food into the freezer in order to ensure better freezing results. Place the food to be frozen on the bottom compartment. Fast freezing For quick-freezing, press the N/S knob (D). The quick-freezing indicator light (C) will then light up. If the quick-freezing function is not ended manually, the appliance switch off the quick-freezing function after 52 hours. The quick-freezing function can be ended manually at any time by pressing the button (D) again. The yellow light goes out. 27 Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least two hours on the quick freezing setting, then return to the normal operating position. [. . . ] Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2). 1 2 D022 Fasten the appliance with 4 screws provided in the kit included with the appliance I Press in the joint covers between the appliance and the kitchen unit. 32 D724 Apply covers (C-D) on joint cover lugs and into hinge holes. Snap vent grille (B) and hinge cover (E) into position. D C E B Separate parts Ha, Hb, Hc, Hd as shown in the figure Ha Hb Hc Hd PR266 Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. ca. 50 mm 90° 21 m m 90° ca. [. . . ]