User manual AEG-ELECTROLUX EW1013I

[. . . ] 132984330. qxd 21/07/2005 10:19 Pagina 1 (Nero/Process Black pellicola) WASHING MACHINE INS T RU C T I ON B OO KLET EW 1013 I 132 984 330 GB 132984330. qxd 21/07/2005 10:19 Pagina 2 (Nero/Process Black pellicola) Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Installation This appliance is heavy. [. . . ] Select the hottest cotton wash programme. Use a normal measure of detergent, must be a powder (such as Ariel Futur). P0038 Cleaning the filter The water drain filter A clean filter is important for the correct operating of the machine, and should therefore be cleaned after every washing programme. Place a container underneath to catch any spillage. If the filter is blocked and the machine is unable to drain you will need to drain the water manually from the machine at this stage. To do this, unhook the drain hose from the standpipe or sink and hold the end of the hose over a bowl on the floor. The water should drain by gravity into the bowl. When the bowl is full, hook the hose back up and empty the bowl. Repeat the procedure until water stops flowing out. External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder. To aid cleaning, the top part of the additive compartment should be removed. P0037 16 132984330. qxd 21/07/2005 10:19 Pagina 17 (Nero/Process Black pellicola) Unscrew and remove the filter. Clean carefully under a fast running tap. The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. Unhook the drain hose from the rear support and position the end of this hose and that of the inlet hose in a bowl. Run the draining programme "P". Screw the inlet hose and reposition the drain hose. When you intend to start the machine up again, make sure that the room temperature is above 0°C. P0039 P0040 Warning When the appliance is in use and depending on the programme selected there can be hot water in the filter. Never remove the filter during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the filter, ensure it is securely retightened so as to stop leaks and young children being able to remove it. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: pull out the plug from the power socket; close the water tap; if necessary, wait until the water has cooled down; Unscrew and remove the filter; place a bowl on the floor. The water should drain by gravity into the bowl. Repeat the procedure until water stops flowing out; clean the filter if necessary as previously described; screw the filter again. Cleaning the water inlet filter If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. It is therefore a good idea to clean it from time to time. Clean the filter using a hard bristle brush. [. . . ] The distance between the holes hobs fixing centres must be 416 mm. The distance (B) from upper edge of the door to the centre of the hole depends on the adjacent furniture's dimensions. The required dimensions are given in the picture C. The hinges will be fixed to the door by means of screws for wood (2-Fig. [. . . ]