User manual AEG-ELECTROLUX EW543F

[. . . ] Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). This numbers guide you step by step in operating the unit. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentallyresponsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". 2 Contents Instructions for use . [. . . ] 23 Washing Drum The washing drum is made of high-quality stainless steel. Rust deposits on the drum can occur due to foreign bodies in the washing which can cause rust. Do not clean the stainless steel drum with acidic antiliming agents, scouring agents containing chlorine or iron or steel wool. Our Customer Service Department has suitable agents available. Remove any rust deposits on the drum using a stainless steel cleaning agent. Filling Door Check regularly whether there are deposits or foreign bodies in the rubber sleeve behind the filling door and, if so, remove them. Cleaning the drain pump Paper clips, nails and so on can sometimes get into the washing machine with the washing and remain in the drain pump casing. Fluff and strands of fabric can gather on these items and block the drain pump. Therefore the drain pump should be cleaned at least once a year. Switch off the washing machine and pull out the mains plug before cleaning the drain pump!First carry out an emergency emptying (see section "Carry Out Emergency Emptying"). Place a towel on the floor in front of the cover of the solution pump. Unscrew the drain pump cover anticlockwise and pull it out. 1 4. uneven surface. The water could not be completely pumped off before spinning because the drainage hose is bent or the drain pump is blocked. 26 Problem The washing solution of the main wash froths up a lot. Possible Cause Too much detergent was probably used The screw connection on the intake hose is leaky. The drainage hose is leaky. Remedy Meter the detergent exactly in accordance with the manufacturer's information. Tighten the intake hose screw connection Check the drainage hose and replace it if necessary. The drain pump cover is not correctly Close cover correctly. Water runs out under the washing machine. Abort the program, remove washing from the door and start a new program. Shut the emergency drain hose off properly (see section "Carry Out Emergency Emptying"). Call your after-sales service if the emergency drain hose is not water-tight. Turn off the tap, then remove the plug from the mains and inform Customer Service. The emergency drain hose is not properly shut off or it is not watertight. The drain pump for the washing machine runs constantly - even when the appliance is switched off. Conditioner not added, compartment æ for care agent full of water. The Aqua Control anti-flood system has been activated. Filter insert in the compartment for Clean the detergent drawer and firmly care agent not correctly attached or is attach the filter insert. Pay attention to the maximum filling quantity (see Program tables). [. . . ] Only original hoses may be used for extension purposes (max. 3m on the floor and then up to 80cm high). The Customer Service stocks hoses in lengths of 2. 7 and 4m. It is absolutely essential to install the drainage hose free of pinches. Water Drainage into a Siphon The grommet on the end of the hose fits all commonly used siphon types. [. . . ]