User manual AEG-ELECTROLUX EWA 3130

[. . . ] · Never use the flex to pull the plug out of the socket but pull the actual plug. · If the mains cord of this appliance is damaged, it has to be replaced by the manufacturer or its customer service or a trained electrician to avoid risks. · Never use the kettle if it has been dropped or has evidently been damaged. · Repairs to the kettle may only be carried out by qualified personnel. [. . . ] Please contact the AEG customer service department or an authorised dealer in the event of repairs being necessary. · Always pull out the plug, ­ before cleaning and attending to the kettle, ­ and after each time it is used. 3 2 Next to this symbol you receive additional information and practical tips on using the appliance. Tips and information about the economical and environmentally friendly use of the machine are marked with the clover. Description of the appliance A lid B lid-opening button C external water level display (including pilot light) D handle E ON/OFF switch F separate base and mains cable G type plate H stainless steel housing Safety of children · Only use the express kettle when supervised. · Supervise children particularly carefully! 6 g Points to be remembered when operating the express kettle · Before starting the appliance ensure that the mains cord and plug are dry. · Never use the kettle with wet hands. · Never use the appliance outdoors. · Whilst using the express kettle, high temperatures are reached which can cause scalding if the kettle is not handled carefully. Therefore only hold the appliance by the handle (D) provided. · Do not use the kettle unsupervised. Do not place or use the kettle on hot surfaces or near naked flames. Place the kettle onto the base in any position you wish. Press the ON/OFF switch down, the pilot light in the external water level display (C) lights up and the kettle starts to heat up. 7 g 3 3 The ON/OFF switch (E) only catches when the kettle is on the base unit (F). Do not use the water from the first boiling cycle to prepare food. Descaling The appliance should be descaled regularly depending on the level of the water hardness. Use a standard descaler following the directions; preferably choose an environmentally friendly product. 0 First fill in water, then a standard descaling preparation which is not too strong. The automatic switch off The kettle will switch itself off automatically and the pilot light will go out when the water has boiled. If you want to stop the heating process before the kettle automatically switches off, simply press the ON/OFF switch (E) up or lift up the jug from the base. If you want to reheat water which has already been heated, press the ON/OFF switch (E) down again. When the water is boiling the kettle switches itself off automatically. 1 Do not boil the solution as it could foam over. 0 After descaling, rinse the kettle out thoroughly with clean water. Never pour descaling agents into an enamel sink and do not reuse them. Technical data Mains voltage: 230V/50Hz Power drain: 1800 W Safety system All AEG kettles are equipped with a boil-dry safety cut-out. [. . . ] Never pour descaling agents into an enamel sink and do not reuse them. Technical data Mains voltage: 230V/50Hz Power drain: 1800 W Safety system All AEG kettles are equipped with a boil-dry safety cut-out. This feature protects the appliance from overheating when started without water or from boiling until it is empty if used with the lid open. If the appliance is accidently switched on without water, it is automatically protected against overheating. The heating process is automatically interrupted. [. . . ]