User manual AEG-ELECTROLUX EWF 14781W

[. . . ] Switching on the appliance/selecting a programme. Changing the spin speed/selecting rinse hold . Interrupting a programme/adding washing. End of the wash cycle/removing the washing . [. . . ] 2. Remove the conditioner insert from the middle compartment. 4. Put the conditioner insert in as far as it will go, so that it is firmly in place. 5. Clean all parts of the washing machine, especially the nozzles in the top of the washing-in chamber, with a brush. 6. Insert the detergent dispenser drawer in the guide rails and push it in. Washing drum Rust deposits in the drum may occur due to rusting foreign bodies in the washing or tap water containing iron. Do not clean the drum with acidic descaling agents, scouring agents containing chlorine or iron or steel wool. 1. Remove any rust deposits on the drum with a cleaning agent for stainless steel. 2. Run a washing cycle without any washing to clean off any cleaning agent residues. Programme: COTTONS/LINEN 95, press the QUICK WASH button, add approx. 1/4 measuring cup of detergent. 18 Door and rubber collar Regularly check whether deposits or foreign bodies are present in the folds of the rubber collar or on the inside of the glass door. Clean the glass in the door and the rubber collar regularly. What to do if. . . Remedying small malfunctions If one of the following fault codes is displayed in the multi-display during operation: ­ E10 (Problems with water inlet), ­ E20 (Problems with water drainage), ­ E40 (door open), please have a look at the following table. When the fault is remedied, press the START/PAUSE button. In the event of other faults (E plus a number or a letter): Switch the appliance off and on again. Please contact the Customer Care Department. Remove foreign bodies from pump housing. Maximum pumping height of E20 appears. END indicator flashes 2x, at the same time an acoustic signal sounds Drain pump is blocked. (Problems with water outflow. ) With connection to sink outlet: Clean out sink outlet. Conditioner insert in the comConditioner not rinsed in, partment for additives is not w compartment for addicorrectly attached or is tives is filled with water. Clean detergent dispenser drawer, insert conditioner insert firmly. Programme continues, when power cut is over. (All display indicators are off. ) Door remains locked for 4 to 10 minutes. To remove washing: If water can be seen in the appliance, before opening the door, first drain off the water. (See section "Carrying out an emergency drain". ) Observe maximum loads. Door cannot be opened when appliance is switched on. Washing is heavily creased. Possibly too much washing was loaded. If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum · Too little detergent is being used. · The right detergent was not used. [. . . ] After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. 4. Connect the hose to a tap with a 3/4" thread. Always use the hose supplied with the appliance. Installation should comply with local water authority and building regulations' requirements. A minimum water pressure of 0. 05 MPa (0. 5 bar) is required for safe operation of the appliance. [. . . ]