User manual AEG-ELECTROLUX EWF1480-W

[. . . ] W a s h i n g M a c h i n e User Information EWF 1480 822 943 373-01 - 13. 11. 02-01 g Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. [. . . ] Close the emergency emptying hose and place it in the holder. 7. Close the flap. 25 What to do if . . . Remedying Faults In the event of a fault, try to solve the problem yourself with the aid of the information provided here. If you call Customer Service to deal with one of the faults listed here or to remedy an operating fault, the customer service technician's visit will not be free of charge, even during the warranty period. · It the fault code C1 or C2 appears in the multi-display, you may be able to remedy the fault yourself (see the fault table below). After remedying the fault, press the button START/PAUSE (Marche/Pause). If the fault code is displayed again, please inform the Customer Service. · In the case of all other displayed faults (C and number or letter), please inform the Customer Service and state the fault code. Problem Possible Cause The mains plug is not plugged in. Remedy Plug in the mains plug. The fuse of the building's wiring is not Replace the fuse. The filling door is not correctly closed. The button START/PAUSE (Marche/ Pause) was not pressed for long enough. Filter in screw connection of the intake hose is blocked. Close the filling door; The lock must engage audibly. Press the button START/PAUSE (Marche/Pause) until the program begins. Cancel the child lock (see section , , Child Safety Feature"). Unscrew the hose from the water tap, remove the filter and clean it under running water. Water tap is blocked with limescale or Check water tap and have it repaired is faulty. Remove transport packaging accordThe transport packaging has not been ing to the installation and connection removed. The height-adjustable screw feet are not correctly set. Adjust in accordance with the installation and connection instructions. Check the laying of the drainage hose and eliminate the bend if necessary, or clean the drain pump and, if required, remove foreign bodies from the pump housing. The washing machine vibrates during operation or it is on an There is not much washing in the drum (e. g. uneven surface. The water could not be completely pumped off before spinning because the drainage hose is bent or the drain pump is blocked. 26 Problem The washing solution of the main wash froths up a lot. Possible Cause Too much detergent was probably used The screw connection on the intake hose is leaky. The drainage hose is leaky. Remedy Meter the detergent exactly in accordance with the manufacturer's information. [. . . ] Secure the grommet/siphon connecting point with a hose clamp. Draining the water into a basin Attention!­ Small basins are not suitable for draining the water into them. ­ It is not permitted to submerge the end of the drainage hose into the pumped-off water. Water could be sucked up into the hose! ­ When hooked into a wash-basin or a bath tub the drainage hose must be protected from slipping out of place by the supplied slip-on elbow. [. . . ]