User manual AEG-ELECTROLUX EWM11044EDU

[. . . ] EWM 11044 EDU . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EN WASHING MACHINE USER MANUAL 2 www. electrolux. com CONTENTS 1. 22 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. [. . . ] Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 9. 2 Using detergent and additives 2 1 • Measure out the detergent and the fabric conditioner. • Carefully close the detergent drawer. 1 2 Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). ENGLISH 13 Liquid or powder detergent 1. 4. B • Position A for powder detergent (factory setting). When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the delay start. 9. 3 Setting a programme 1. Turn the programme knob and set the programme: – The indicator flashes. – The display shows the level of the Time Manager, the programme duration and the indicators of the phases of the programme. If necessary, change the temperature and the spin speed or add available options. When you activate an option, the indicator of the set option comes on. If you set something incorrect, the display shows the message Err. 9. 4 Starting a programme without delay start Press : • The indicator stops to flash and stays on. • The indicator starts to flash on the display. • The programme starts, the door is locked and the display shows the indicator . • The drain pump can operate for a short time when the appliance fills water. 2. 14 www. electrolux. com After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. 9. 8 Opening the door While a programme or the delay start operates, the appliance door is locked and the display shows the indicator . If the temperature and level of the water in the drum are too high, you cannot open the door. Open the appliance door when the delay start operates: 1. 4. 9. 5 Starting a programme with delay start • Press again and again until the display shows the delay you want to set. The related indicator comes on the display. : • Press – The appliance starts the countdown. [. . . ] This problem may be caused by balance problems. Make sure that the couplings of the water hoses are tight and there is not water leakages. Make sure that the drain hose have no damages. Make sure you use the correct detergent and the correct quantity of it. [. . . ]