User manual AEG-ELECTROLUX EWP0864TDW

[. . . ] EWP 0864 TDW EWP 1064 TDW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EN WASHING MACHINE USER MANUAL 2 www. electrolux. com CONTENTS 1. 21 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. [. . . ] Put a small quantity of detergent in the compartment for washing phase. 3. Set and start a programme for cotton at the highest temperature without laundry. This removes all possible dirt from the drum and the tub. 9. • Connect the mains plug to the mains socket. 9. 1 Loading the laundry 1. Put the laundry in the drum, one item at a time. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 9. 2 Using detergent and additives When you set a programme with a prewash, put the detergent for prewashing phase directly into the drum. • Measure out the detergent and the fabric conditioner. • Carefully close the detergent drawer. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Flap for powder or liquid detergent. ENGLISH 13 Liquid or powder detergent 1. 2. A 3. 4. B • Position A for powder detergent (factory setting). When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the delay start. 9. 3 Setting a programme 1. Turn the programme knob and set the programme: – The indicator flashes. – The display shows the level of the Time Manager, the programme duration and the indicators of the phases of the programme. If necessary, change the temperature and the spin speed or add available options. When you activate an option, the indicator of the set option comes on. If you set something incorrect, the display shows the message Err. 9. 4 Starting a programme without delay start Press : • The indicator stops to flash and stays on. • The indicator starts to flash on the display. • The programme starts, the door is locked and the display shows the indicator . [. . . ] Set the drain programme if you set a programme without drain phase. Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. [. . . ]