User manual AEG-ELECTROLUX EWS1254EDU

[. . . ] EWS 1254 EDU . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . EN WASHING MACHINE USER MANUAL 2 www. electrolux. com CONTENTS 1. 21 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. [. . . ] Make sure not to put too much laundry in the drum. Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 12 www. electrolux. com 9. 2 Using detergent and additives 2 1 • Measure out the detergent and the fabric conditioner. • Carefully close the detergent drawer. 1 2 Detergent compartment for prewash phase. Detergent compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch). Liquid or powder detergent 1. 4. B ENGLISH 13 • Position A for powder detergent (factory setting). When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the delay start. 9. 3 Setting a programme 1. Turn the programme knob and set the programme: – The indicator flashes. – The display shows the level of the Time Manager, the programme duration and the indicators of the phases of the programme. If necessary, change the temperature and the spin speed or add available options. When you activate an option, the indicator of the set option comes on. If you set something incorrect, the display shows the message Err. The related indicator comes on the display. : • Press – The appliance starts the countdown. – When the countdown is completed, the programme starts automatically. You can cancel or change the set of the delay start before you press . 1. 2. 2. To cancel the delay start: Press to set the appliance to pause. Press until the display shows Press again to start the programme immediately. ’. 9. 4 Starting a programme without delay start Press : • The indicator stops to flash and stays on. • The indicator starts to flash on the display. • The programme starts, the door is locked and the display shows the indi. [. . . ] Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually. Set the spin programme. Make sure that the drain filter is not clogged. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. Make sure that the couplings of the water hoses are tight and there is not water leakages. ENGLISH 21 Problem Possible solution Make sure that the drain hose have no damages. [. . . ]