User manual AEG-ELECTROLUX EWT0862EOW

[. . . ] 4. The symbols 1 2 3 4 5 electrolux 3 Dispenser box Prewash Wash Softener (do not fill above the MAX symbol M ) SAFETY INFORMATION Please read these points carefully before installing and using your appliance. Keep this user manual with your appliance. General safety · Do not modify or attempt to modify this appliance. · Ensure that all coins, safety pins, brooches, screws etc have been removed before starting a washing programme. [. . . ] At the end of the programme, if you have or "Night cycle selected "Rinse hold" plus" , you then need to select a "Spin" or "Drain" programme to finish the cycle and empty the water. Selecting options You must select the different options after selecting the programme and before pressing the "Start/Pause" pushbutton (see "Programme table"). Press the desired button(s) ; the corresponding lights come on. If one of the options is not compatible with the selected programme, "Err" flashes on the display and the "Start/Pause" pushbutton flashes red. "Prewash" option The appliance runs a prewash at 30°C max. "Hot water connection" option This appliance is provided with two inlet hoses : one for the cold water and one for the hot water. By default, the Cottons and Synthetics programmes benefit to the connection to the available hot water of your domestic installight lation. The "Hot water connection" illuminates. Press the "Hot water connection" pushbutto interrupt the hot water loading : ton the corresponding light s'éteint goes off. The machine will only load then cold water, which will be warmed up by the heating element of the appliance. "Rinse plus" option The washing machine will add one or more rinses during the cycle. Press the "Start/Pause" pushbutton again to continue the programme. Modifying the programme in progress Before making any changes to the current programme, you need to pause the washing machine by pressing the "Start/Pause" pushbutton. If the modification is not possible, "Err" flashes in the display and the "Start/Pause" pushbutton flashes red for a few seconds. If you still decide to change the programme, you must cancel the current programme (see below). Cancelling the programme If you want to cancel the programme, turn the programme selector to the "Stop" posi. tion End of the programme The washing machine stops automatically ; the "Start/Pause" pushbutton goes out and "0" flashes on the display. The lid can only be opened around 2 minutes after the washing machine has come to a stop. Turn the programme selector to the "Stop" position. Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. The brightness of the display is reduced. By pressing any button the appliance will come out of the energy saving status. PROGRAMMES TABLE Programme / Type of washing (cold - 90°) : White or colour, e. g. [. . . ] Detergent tablets or doses must be placed in the detergent compartment of your appliance's dispenser box. TECHNICAL SPECIFICATIONS DIMENSIONS Height Width Depth 850 mm 400 mm 600 mm 230 V / 50 Hz 2300 W Minimum Maximum 0, 05 MPa (0, 5 bar) 0, 8 MPa (8 bar) Type 20/27 LINE VOLTAGE /FREQUENCY POWER CONSUMPTION WATER PRESSURE Connection to water supply INSTALLATION Remove all protective packaging for transit before using for the first time. Keep in case needed for future transit: Transporting a non-secured appliance may damage internal components and cause leakages and malfunctions. The appliance can also be damaged through physical contact. electrolux 11 Unpacking 1 2 them pass in the throat planned for that purpose. The hot water hose is provided with a red nut and must be linked to the tip equipped with a red disk. [. . . ]