User manual AEG-ELECTROLUX EWT 10115 ERRATA

[. . . ] General safety · Do not modify or attempt to modify this appliance. · Ensure that all coins, safety pins, brooches, screws etc have been removed before starting a washing programme. If left in washing, they can seriously damage the appliance. · Use the recommended quantity of detergent. [. . . ] " Rinse plus " option The washing machine will add one or more rinses during the cycle. This option is recommended for people with sensitive skin and in soft water areas. Temporary : Press the " Rinse plus " pushbutton. The option is only active for the selected programme. Permanent : Hold down the " Temperature " and " Option " pushbuttons for a few seconds. The option is permanently activated, even if the appliance is switched off. " Delay start " This option allows you to delay the start of a wash programme by 3, 6 or 9 hours by pressing the " Delay start " pushbutton. You can change or cancel the delayed start time at any time before you press the " Start/Pause " pushbutton by pressing the " Delay start " pushbutton again (when all indicators are off, the wash programme will start immediately). If you have already pressed the " Start/Pause " pushbutton and you want to change or cancel the delayed start, proceed as follows : · To cancel the delay start and start the cycle immediately, press " Start/Pause " and then " Delay start " . Press " Start/Pause " to start the cycle. · To change the timer delay period, you must go through the "Stop" position and reprogramme your cycle. Modifying the programme in progress Before making any changes to the current programme, you need to pause the washing machine by pressing the " Start/Pause " pushbutton. If the modification is not possible, the " Start/Pause " pushbutton flashes red for a few seconds. If you still decide to change the programme, you must cancel the current programme (see below). Cancelling the programme If you want to cancel the programme, turn the programme selector to the "Stop" position . End of the programme The washing machine stops automatically, the " Start/Pause " pushbutton goes out and the light "End of cycle" comes on. The lid can only be opened around 2 minutes after the washing machine has come to a stop. Turn the programme selector to the "Stop" position. Unplug and close water inlet tap. PROGRAMMES TABLE Programme / Type of washing Cottons (cold - 90°) : White or colour, e. g. normally soiled work clothes, bed linen, table linen, body linen, towels. Synthetics (cold - 60°) : Synthetic fabrics, body linen, fab, coloured farics, non-iron shirts, blouses. Delicates (cold - 40°) : For all delicate materials, for example curtains. [. . . ] · the drain hose is blocked or bent, · the drainage filter is obstructed, · the out of balance detector has been activated : washing is unevenly distributed in the drum, · the "Drain" programme or "Night Silence Plus" or "Rinse hold" option have been selected, · the height of the drainage U-piece is unsuitable. · · · · · · · · · too much detergent has caused foam to overflow, the detergent is unsuitable for machine washing, the drainage U-piece isn't attached correctly, the drainage filter hasn't been put back in place, the water inlet hose is leaking. the detergent is unsuitable for machine washing, there is too much washing in the drum, the wash cycle is unsuitable, there isn't enough detergent. The appliance fills but empties straight away: The washing machine doesn't rinse or doesn't empty: You have found water around the washing machine: Wash is unsatisfactory: The appliance vibrates, is noisy: · all packaging have not been removed from the appliance (see installation section), · the appliance isn't level and is unbalanced, · the appliance is too close to the wall or furniture, · washing is unevenly distributed in the drum, the load is too small, · the appliance is in running in period, noise will disappear with time. The appliance can also be damaged through physical contact. [. . . ]