User manual AEG-ELECTROLUX EWT1066EDW

[. . . ] The following symbols have been used in this user guide : Important information about concerning your safety and information on how to avoid damaging the appliance. These warnings are for the safety of you and others around you. Please read these points carefully before installing and using your appliance. Keep this user manual with your appliance. [. . . ] Load the washing, close the drum and the lid of your washing machine. The symbols which correspond to the different stages of the cycle are displayed ( Prewash, Wash, Rinse, Drain, Spin). Before closing the lid of your appliance, ensure that the drum is properly closed : · When the two shutters are closed, · You can therefore If you turn the programme selector to another programme while a cycle is in progress, the appliance will ignore the new selected programme. "Err" flashes and the "Start/Pause" pushbutton flashes red for a few seconds then the current cycle display reappears. 10 how to run a wash cycle At the end of the programme, if you have selected "Rinse hold" or "Night silence plus", you then need to select a "Spin" or "Drain" programme to finish the cycle. Press the "Temperature" pushbutton repeatedly to increase or decrease the temperature if you want your washing to be washed at a different temperature to the one selected by the appliance. "Night silence plus" The washing machine does not empty the water after the final rinse which prevents the washing from creasing. Because there are no spin cycles, the washing programme is very quiet and can be selected at night. in Cotton and Synthetics programmes , the rinsing cycle uses more water. "Rinse hold" The washing machine will not drain the water from the last rinse, so will not crease the laundry. Selecting options You must select the different options after selecting the programme and before pressing the "Start/Pause" pushbutton (see "Programme table"). The lid can only be opened around 2 minutes after the washing machine has come to a stop. How to run a wash cycle 13 Modifying the programme in progress Before making any changes to the current programme, you need to pause the washing machine by pressing the "Start/ Pause" pushbutton. If the modification is not possible, "Err" flashes in the display and the "Start/Pause" pushbutton flashes red for a few seconds. If you still decide to change the programme, you must cancel the current programme (see below). Cancelling the programme If you want to cancel the programme, turn the programme selector to the "Stop" position. End of the programme The washing machine stops automatically ; the "Start/Pause" pushbutton goes out and "0" flashes on the display. The lid can only be opened around 2 minutes after the washing machine has come to a stop. If the appliance is on but no commands are selected for 10 min before or after a cycle, it goes into standby mode. The screen light goes out and "Start/Pause" flashes slowly. To exit standby mode, simply press any pushbutton or turn the programme selector. We recommend leaving the lid and drum open after use to ventilate the water tank. [. . . ] Easy iron : Reduces creasing and makes ironing easier. Spin : A spin cycle from 400 to 1100 rpm after a Rinse hold (or Night silence plus). Drain : Runs an empty cycle after a Rinse hold or (Night Silence Plus). Rinses : Hand washed items can be rinsed in this programme. [. . . ]