User manual AEG-ELECTROLUX EWT1201

[. . . ] 13 Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Technical characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] You will then hear a double "click" in the locking device when the cover opens. Press the same pushbutton again to resume the programme. For reasons of safety, you cannot open the cover if the temperature of the washing water is too high. 3. 6. 2. Modifying the current programme Before modifying the options of the current programme, you must put the washing machine to pause by pressing on the Start/Pause pushbutton . If it is impossible to make the modification, the corresponding light flashes for few seconds. If you decide to change the programme in any case, you will need to cancel the current programme (see below). 3. 6. 3. Cancelling the programme If you want to cancel a programme, turn the programme selector knob to the «Off» position of the programme selector. You can then select a new programme. 3. 7. End of programme The washing machine stops automatically. You will hear a double "click" in the locking device when the cover opens. If you choose the rinse hold position*, the rinse hold light* illuminates to inform you that water has to be drained before you can open the cover. Tablet detergents or individually dosed detergents must be placed in the washing compartment of the detergent drawer in your appliance. To treat stains before the washing cycle, follow the doses and instructions recommended by the manufacturer of the product. If you use the detergent product to treat stains, you must start the washing cycle immediately. · · · · · · · 5. 2. Washing load depending on the nature of the material The quantity of washing that you put in your drum must not exceed the maximum capacity of your washing machine. This capacity may vary depending on the nature of your textiles. Reduce the quantity of washing if it is very dirty or if you have terry cloth type materials. Not all textiles have the same volume and the same water retention capacity. This is why in general the drum should be filled: · · · completely, but without excessive pressure for cotton and linen, and for mixed washe, half full for treated cottons and synthetic fibers, about one third full for very delicate articles such as net curtains and wool. For a mixed wash, fill the drum as required for the most delicate material. 8 5. 4. International symbols for care of textiles NORMAL WASH Wash at 95°C DELICATE WASH Wash at 60°C Wash at 40°C Wash at 30°C Delicate wash by hand Do not wash JAVEL WATER Bleaching with chlorine (Javel water) allowed (only cold and with a dilute solution) Do not bleach with chlorine (Javel water) IRONING High temperature (max 200°C) Average temperature (max 150°C) Low temperature (max 100°C) Do not iron DRY CLEANING Dry cleaning (all usual solvents) Dry cleaning (all solvents except trichloroethylene) Dry cleaning (only oil solvents and R113) High temperature Moderate Temperature Do not dry clean DRYING Dry washing spread out Dry washing hung up Dry washing on hanger Drying in drum allowed Do not dry in drum 9 6. CARE AND CLEANING Do not do any cleaning operation until you have unplugged the washing machine. 6. 4. The drain filter Clean the filter at the bottom of the washing machine regularly. [. . . ] TECHNICAL CHARACTERISTICS DIMENSIONS Height Width Depth 850 mm 400 mm 600 mm 230 V / 50 Hz 2300 W Minimum Maximum 0, 05 MPa (0, 5 bar) 0, 8 MPa (8 bars) Type 20x27 VOLTAGE / FREQUENCY TOTAL POWER WATER PRESSURE Connection to the water network This washing machine complies with CEE directive 89-336 about the limitation of radioelectric disturbances and directive CEE 73-23 for electrical safety. 13 3. Unpacking Packing used to protect internal parts of the washing machine during transport must be removed before the washing machine is put into service for the first time. Remove all packing from the washing machine. Tilt the washing machine sideways and then remove the packing under the motor, and straighten the washing machine. If you want to keep your washing machine aligned with the adjacent furniture, you can cut the pipe support strip at the back of your washing machine. [. . . ]