User manual AEG-ELECTROLUX EWT719

[. . . ] WASHING MACHINE INSTRUCTION BOOK EWT 719 146 4978 01 - 10/03 GB CONTENTS FOR THE USER WARNINGS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Usage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Precautions against frost . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Scrapping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] However, you can reduce the speed or choose the rinse hold*, silence cycle*, drain*, or spinning suppression* positions. 3. 5. Starting the program After you chose the washing program, press the Start/Pause pushbutton to start the cycle. It is normal that the program selector does not turn during the cycle. * depending on model 5 When the washing cycle begins, the «in progress» light is on. 3. 6. Adding of laundry Press the Start/Pause pushbutton : the corresponding light flashes as long as the programme is paused. You will then hear a double "click" in the locking device when the cover opens. Press the same pushbutton again to resume the programme. For reasons of safety, you cannot open the cover if the temperature of the washing water is too high. 3. 6. 2. Modifying the current programme Before modifying the current programme, you must put the washing machine to pause by pressing on the «Start/Pause» pushbutton. If it is impossible to make the modification, the corresponding light flashes for few seconds. If you decide to change the programme in any case, you will need to cancel the current programme (see below). 3. 6. 3. Cancelling the programme If you want to cancel a programme, turn the programme selector knob to the «off» position of the programme selector. You can then select a new programme after cancelling the previous one. 3. 7. End of program The washing machine stops automatically. You will hear a double "click" in the locking device when the cover opens. If you choose the rinse hold position on the spin speed variator, the rinse hold light* illuminates to inform you that water has to be drained before you can open the cover. To terminate the cycle, you can then spin the washing by choosing the spin program or drain it by choosing the drain program. Turn the program selector knob to the "Off" position. Pull out the power supply plug and close the water supply tap. Note: we recommend that you should leave the cover and the drum open after use to air the washing drum. *depending to the model 6 4. PROGRAMS TABLE The following does not show all possibilities, but simply the most frequent settings. Program Washing type Load Possible options Temperatures °C White / Coloureds White or color, for example normally dirty work clothes, bed linen, table linen, underwear, towels. Easy Ironing Synthetics Synthetic fabrics, underwear, color fabrics, noniron shirts, blouses. [. . . ] Tilt the washing machine sideways and then remove the packing under the motor, and straighten the washing machine. If you want to keep your washing machine aligned with the adjacent furniture, you can cut the pipe support strip at the back of your washing machine. Leave the two side closers in place. 3. 2. Position Put the washing machine on a flat hard floor in a well ventilated room. Make sure that your washing machine does not touch the wall or any other furniture in the room. 3. 3. [. . . ]