User manual AEG-ELECTROLUX EX41XS

[. . . ] - The oven accessories which may be in contact with food are made from materials which comply with the essential requirements and other national provisions in force. - The conformity of this appliance to the above mentioned Directives is proved by the symbol stated in the rating plate placed on the appliance rear wall. - This appliance was designed for domestic use only and not for professional custom. - These instructions should be applied in the Countries where the appliance will be sold and whose identification symbol appears in the front page of the operator's handbook and on the appliance, only. - Always open the door before you switch on the oven burner. [. . . ] By rotating the knob clockwise you will read the following symbols: l To switch on a single heating element rotate the knob clockwise from zero "0" to the desired position. To switch on the second heating element rotate the knob clockwise as far as it gets the symbol, then release the knob and set the desired position. Burner TC (triple burner) R (large) SR (medium) A (small) Use flat bottom pots only. Pot diameter from 220 to 260 mm from 220 to 260 mm from 160 to 240 mm from 120 to 140 mm WORK SURFACE ELECTRIC HEATING ELEMENTS - FUNCTIONING AND INSTRUCTIONS FOR USE General information and precautionary measures To obtain the highest performance with the lowest electrical input we suggest you to proceed as follows: - Turn on the power only after having put the pot on the hot plates or cooking unit. - Do not use pots with a diameter lower than that of the hot plates or cooking unit. - Use flat bottom and high thickness pots. - Dry the pot bottom before resting it on the hot plates or cooking unit. - If cooking times are longer than 40 minutes turn off the power of the hot plates or cooking unit 5-10 minutes before the end of the cooking time to exploit the residual heat. - Do not use the pyroceram cooking surface as a bearing surface and also be careful not to hit it with hard and sharp objects. - Do not stare at the halogen heating elements of the pyroceram cooking surface. - Do not creep the pyroceram cooking surface with pots or other objects. - Remove poured out liquids from the cooking unit by means of the scraper purposely studied for pyroceram cooking surfaces. - Should the range be fitted with crystal top this might explode if heated, therefore mind to turn off hot plates or heating elements before closing the top. - As soon as you note a crack of the pyroceram cooking surface disconnect the appliance from the electric supply immediately. - Always grasp the central part of the handle to open the oven door. - During or at the end of cooking, on the opening of the oven door you should always be careful to the boiling fumes emission. - Always use insulating gloves to put in and to take out pots from the oven. - Use pots resistant to the temperatures stated in the thermostat knob. - After you finished to use the appliance make sure that all controls are turned to the OFF/CLOSED position. The gas grill burner always work at its highest power. To cook with gas grill, place grill onto the highest guide and the dripping pan onto the underneath guide. Manual ignition Open the door, install the knobs heat buffer (supplied with the appliance), light a match and bring it near the burner, then push and rotate the knob clockwise up to the grill position identified by the symbol: . Once the oven is switched on, keep the knob pressed for about 5-10 seconds and make sure that burner stays on. Now bring the oven door near the heat buffer. The knobs heat buffer can be manually operated by means of the two bushes placed under the facia-panel. [. . . ] Electric clock supplied with cooking end device Range can be fitted with this double functional accessory: it consists of a clock able to turn off oven automatically when the set cooking time has run out. To set hour push and rotate the small knob counterclockwise. To set minutes rotate the small knob counterclockwise without pushing it. When the set time has run out the acoustic warning signal starts to inform that oven is off. [. . . ]