User manual AEG-ELECTROLUX EXD25DN3W

[. . . ] Safety information Before first use Operating instructions 2 3 4 Care and cleaning 8 What to do if. This USER MANUAL provides specific operating instructions for your model. Use the room air conditioner only as instructed in this USER MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. [. . . ] Plug the power cord into a properly grounded 220 V AC outlet. The unit will run in the facbutton tory setting of CONTINUOUS and high fan speed. In the CONTINUOUS mode, the unit will only display CO and not the room humidity. It is recommended you leave the unit running in the CONTINUOUS setting for the first three or four days until the sweating and dampness odors have stopped. After a few days when the Relative Humidity has declined, press the HUMIDIor buttons to choose a value TY between 35% to 85%, so the room is kept at a comfortable humidity. pressor buttons will change ing the the humidity selection in 5% increments. After you have set the desired humidity, the readout will display the actual room humidity. If at any time you want to return to the CONTINUOUS butMode, pressing the HUMIDITY ton will lower the Relative Humidity through the 5% increments until the display reads CO. You can also use the FAN SPEED button to change the fan speed to HIGH or LOW. The indicator light will show the setting you have selected. A higher fan speed will result in quicker moisture removal. The TIMER function enables you to either Delay Start or Delay Stop the unit in the choice from 0. If the unit is running, then selecting Timer will turn the unit off in the hours that will be set (Delay Stop). If the unit is off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start). TIMER setting: , then adFirst press TIMER button just timer setting, by tapping or holding or button to change the dethe lay timer at 0. 5 hour increments, up to 10 hours, then by 1 hour increments up to 24 hours. ) until the unit either starts or stops. for the Delay Start , the fan speed and humidity maintained will be the same as previous setting. After TIMER setting finishes, pressing TIMER button again at any time will stop the TIMER function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens the above steps have to be repeated. ­ Before entering TIMER setting, make sure power is being supplied to the unit. [. . . ] If you want to remove more moisture, Select CONTINUOUS by using the humidity button or knob. After the dehumidifier starts, reset the control to the desired setting. Dehumidifier automatically turns off when this occurs. Empty bucket and return bucket to position. [. . . ]