User manual AEG-ELECTROLUX EXI12HA1WI

[. . . ] 3. 5 After setting the TIMER, there will be a one-half second delay before the remote controller transmits the signal to the Air Conditioner. Then , after approximately another 2 seconds, the signal "h" disappears and the set temperature will re-appear on the digital display. Change the TIMER To change the TIMER ON/OFF time, just press the corresponding TIMER button and reset the time. To cancel the TIMER ON/OFF setting, just adjust the TIMER time to 0:00. ! NOTE The setting time is relative time. [. . . ] 1 1 2 12 13 TIMER OFF Button: Press this button to initiate the auto-off time sequence. Each press will increase the auto-timed setting in 30 minutes increments. When the setting time displays 10:00, each press will increase the auto-timed setting 60 minutes increments. To cancel the auto-timed program, simply adjust the auto-off time to 0:00 LOCK Button: Push this button to lock all the current settings, push again to cancel the LOCK function. TURBO Button: Push this button on HEAT/COOL mode, the air conditioner goes into powerful heating/cooling operation. Push again to cancel the TURBO function. DIGITAL DISPLAY Button: Press this button to clear the digit display in the air conditioner, press it again to activate it (Not applicable to units without this function). 3 4 ON/OFF Indicator: This symbol appears when the unit is turned on by the remote controller, and disappear when the unit is turned off. OPERATION MODE Indicator: When press the MODE button, it shows the current operating mode -- AUTO COOL DRY HEAT (Cooling only model without) mode. LOCK Indicator: LOCK display is displayed by pushing the LOCK button. TIMER DISPLAY indicator: This display area shows the settings of the TIMER. That is, if only the starting time of operation is set, it will display the TIMER ON. If only the turning off time of operation is set, it will display the TIMER OFF. If both operations are set, it will show TIMER ON-OFF which indicates you have chosen to set both the starting time and off time. FAN SPEED Indicator: Press the FAN SPEED button to select the desired fan speed setting (Auto-Low-Med-High). You selection will be displayed in the LCD window except the Auto fan speed. NOTE: All signs shown in the Fig. 2 is for the purpose of clear presentation. But during the actual operation only the relative functional signs are shown on the display panel. 5 14 6 15 7 Indicators on Display Panel Display Panel DIGITAL DISPLAY area TRANSMISSION indicator OPERATION MODE Indicator 1 2 4 7 3 4 ON/OFF Indicator OPERATION MODE Indicator ! Operating the Remote Controller FAN SPEED Indicator Install/Replace Batteries Lock indicator 5 TIMER ON OFF TIMER DISPLAY indicator 6 Fig. 2 The Remote Controller uses two alkaline dry batteries(LR03X2). To install the batteries, slide the back cover of the battery compartment and install the batteries according the direction (+and -)shown on the Remote Controller. To replace the old batteries, use the same method as mentioned above. NOTE 1 DIGITAL DISPLAY area: This area will show the set temperature and, if in the TIMER mode, will show the ON and OFF settings of the TIMER. If in the FAN mode, nothing is appeared. TRANSMISSION Indicator: This indicator flashes one time when remote controller transmits signals to the indoor unit. 2 1. [. . . ] If the AUTO mode is not comfortable for you, the desired mode can be selected manually. COOL/ HEAT (Cooling only model without) and FAN Operation 1. If the AUTO mode is not comfortable, you may manually over-ride the settings by using COOL, HEAT or FAN modes. Push the TEMP button to set the desired room temperature. When in COOLING mode, the most comfortable settings are 21 C or above. [. . . ]