User manual AEG-ELECTROLUX F35020IM

[. . . ] Contents Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. [. . . ] In case that plates are loaded in the upper basket, load them starting from the rear positions of the basket, tilting them slightly forwards and avoiding the front positions near the door. Before closing the door, ensured that the spray arms can rotate freely. If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. To move to the higher position proceed as follows: Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the upper basket is raised you will not be able to use the cup racks. After loading your machine always close the door, as an open door can be a hazard. 2) Ideal for washing a partially loaded dishwasher. This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. 4) This programme does not require the use of detergent Turn the programme knob until the programme marker corresponds with the desired programme (see "Washing programmes" chart). Press the START/RESET button, the programme starts automatically and the START/ RESET indicator light illuminates. ­ As soon as the programme starts, the phase indicator lights turn off except for the indicator light for the phase in progress which will remain lit. During the running of the programme, it is not possible to change the selection made by turning the programme knob in correspondence of another programme or the Off position. If you want to change the running programme you must cancel the selection made (see "Cancel a washing programme in progress"). Setting and starting the programme with "delay start" Once the door is closed the countdown will continue from the point at which it was interrupted ­ Once the delay start has elapsed, the washing programme will start automatically, the delay start indicator light turns off, while the indicator light of the phase in progress illuminates. cancelling the "delay start" · Press the START/RESET button for about 5 seconds, the indicator lights of START/RESET and delay start buttons turn off while the indicator lights of the phases start flashing. to start the selected washing programme press the START/RESET button. The washing programme or the countdown of the delay start will begin only after having pressed the START/RESET button. Hot steam may escape when the door is opened. Close the door; the programme will start from the point at which it was interrupted. The START/RESET indicator light turns off and the phase indicator lights are flashing. The running programme has been cancelled and it is now possible to set a new washing programme or switch off the machine. [. . . ] The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher. Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. [. . . ]