User manual AEG-ELECTROLUX F36WC19EEN

[. . . ] F30WC, F36WC, & F42WC SERIES 4-WAY CONVERTIBLE RANGE HOOD READ AND SAVE THESE INSTRUCTIONS !INTENDED FOR DOMESTIC COOKING ONLY ! IMPORTANT For Non-ducted (Ductfree) Installation: a) Purchase non-ducted filter separately. b) Remove and discard damper/duct connector and louver cover (See Step 4) in "Prepare the Hood, Page 2. " c) Follow all steps except steps inside dotted lines. [. . . ] Seal joint between damper/duct connector and hood with duct tape. 7" round ducted discharge only: Re-install 7" round duct plate removed in Step #2 under "PREPARING THE RANGE HOOD" section. For best performance, line up the 7" round duct plate with the 7" round opening on hood. Mount duct plate to hood with 2 screws from duct plate and 2 screws from 3¼" x 10" damper. Install a 7" round damper (purchase separately). Damper flap must open freely in direction of air flow (away from range hood). FIG. 2 KEYHOLE SLOTS ALUMINUM FILTER WIRING BOX COVER DAMPER/DUCT CONNECTOR FIG. 5 PREPARING THE INSTALLATION LOCATION NOTE MOUNT HOOD SO THAT BOTTOM OF HOOD IS 18"-24" ABOVE COOKING SURFACE. TOP FRONT EDGE OF HOOD SHOULD BE FLUSH WITH FRONT OF CABINET FRAME. IF DISTANCE BETWEEN WALL AND FRONT OF CABINET FRAME IS MORE THAN 12" THERE WILL BE A SPACE BETWEEN BACK OF HOOD AND WALL. OMIT STEP 9 if range hood will be installed under cabinets with flush bottom. (For installation on recessed bottom cabinets only) Attach a wood filler strip at each side of recessed area under cabinet. (Use two 1" x 2" strips cut to length. ) If recess is more than 1" use thicker strips. Attach strips with 1-1/4" screws about 3" from each end. 10. Measure and mark the following (FIGS. 7 & 8): a) Electrical line opening b) Duct opening 11. Drill four pilot holes in corners of marked duct opening as shown and cut opening with saber saw or keyhole saw. 12. Use 1-1/4" drill bit to drill opening for electrical connection in wall or cabinet. 13. Hold hood up against cabinet bottom and trace keyhole slots onto cabinet bottom of filler strips. 14. Screw the four supplied 7/8" wood screws for mounting the hood into the exact center of the narrow end of the keyhole slots marked underneath the cabinet. Allow 3/8" of the screws to project, so the hood can be fitted into place. FIG. 7 CUT STRIPS TO FIT 3 DUCT CENTER OPENINGS LINE WIDTH OF RANGE ELECTRICAL HOOD WIRING OPENING INSTALLING THE DUCTWORK NOTE THESE INSTRUCTIONS WILL FOLLOW THE PLANS MADE ON PAGE 2. START AT THE EXTERIOR AND RUN THE DUCT BACK TO THE RANGE HOOD. [. . . ] Food loss due to any refrigerator or freezer failures. Service calls which do not involve malfunction or defects in materials or workmanship, or for appliances not in ordinary household use or used other than in accordance with the provided instructions. Service calls to correct the installation of your appliance or to instruct you how to use your appliance. Expenses for making the appliance accessible for servicing, such as removal of trim, cupboards, shelves, etc. , which are not a part of the appliance when it is shipped from the factory. 10. [. . . ]