User manual AEG-ELECTROLUX F400EGP

[. . . ] Connecting to 12 Volt vehicle battery 9. 3. Connecting to LP bottled gas cylinder 9. 4. Connection of gas supply Environmental protection information Recycling 6. Unpacking After removal from the cardboard packaging, make sure the appliance is not damaged. [. . . ] When opening the lid or putting in food, some of this frost melts and collects in the form of water on the bottom of the appliance. Wipe the water off occasionally using a sponge. Avoid putting foods with fragile packaging (such as glass) into the refrigeration unit. Movements and shaking of the unit may cause these items to break. Once the F 400 is in its permanent position, make sure foods do not come into contact with the evaporator panel, as this can cause freezer-burn to the foods. The appliance is not operated on 12 Volts when your vehicle is parked, otherwise you will drain the battery in a short time. Only one power source is used at a time to run the appliance. 7. Defrosting, cleaning and maintenance For defrosting, always unplug the appliance from an electrical power source to avoid the risk of shock. Make sure no other power source is connected (gas or 12V). Remove food from the refrigeration unit and leave the lid open. Depending on the temperature, frost melts in a short time from the evaporator panel, with water collecting at the bottom of the appliance. Afterwards, clean the appliance by following the instructions in section 3. Leave the lid ajar to prevent any odours from forming. The appliance is serviced depending on use, at least once a year by an authorised service agent. 7 8. Trouble shooting Before calling a service technician please check carefully the operating instructions, service booklet and the warranty terms and conditions: Are location and ventilation satisfactory?Is there a current in the wall socket and is the connection suitable for the appliance?For mains operation, is the electric thermostat swiched on?For gas operation, was the safety valve knob pressed down long enough?Is the thermostat knob set towards the maximum position?Is the gas cylinder or the pressure regulator valve open?(If by shaking, no liquid movement can be detected, then the cylinder is empty. ) Is more than one power source connected (such as gas or electricity)?Was a large quantity of food put in at one time? 9. 1 Make sure no other energy source is connected (gas, 12V). [. . . ] Remove the rubber '0'ring (1) and push it over the end of the nozzle so that it locates in the first corrugation. Push the threaded end ot the Sureflex Pipe against the end of the nozzle, then screw up the nut, tightening the assembly with spanners to make a gastight joint. In both of the above instances, the other end of the Sureflex Pipe should terminate in a 1/4" o. d. In order to connect this to a 1/8" B. S. P. female threaded gas inlet of the appliance a coupling which has a 1/8" B. S. P. [. . . ]