User manual AEG-ELECTROLUX F44860UM

[. . . ] Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information Your dishwasher has the new washing system "IMPULSE WASHING". With this dishwashing system the motor speed and spray pressure are varied during the wash cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents CONTENTS Operating instructions Safety instructions Disposal Economical and ecological dishwashing Description of the appliance The control panel Prior to using for the first time The water softener Filling with dishwasher salt Rinse aid In daily use Loading cutlery and dishes The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent Different kinds of detergent Washing programmes Starting a washing programme Maintenance and cleaning Cleaning the filters What to do, when. . . [. . . ] In the digital display flashes the running time (in minutes) of the selected programme. The programme in progress indicator light illuminates. After about 3 seconds from the last pressure of a button the programme starts automatically. In the digital display the running time of the programme is no longer flashing and the programme in progress indicator light remains illuminated. Setting and starting the programme with the delay start The setting of the delay start occurs before selecting the programme Press the delay start button until the flashing number of the hours for the delay start will appear in the digital display (from 1h to 19h). In the digital display will appear, for a moment, the running time of the programme and then again appears the selected delay start time. As soon as the number of hours is displayed without flashing, the countdown for the delay start is active. The countdown will decrease with steps of 1 hour. 26 Operating instructions The opening of the door during the countdown will not modify the delay start. Once the delay start has elapsed the programme will start automatically. With the delay start option setted, the programme in progress indicator light is off. Once the countdown of the delay start has elapsed, the washing programme will start automatically and the programme in progress indicator light will illuminate. Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler then the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. "3 in 1" function This function can be selected together with all programmes. Place the "3 in 1" combi detergent tablet in the detergent dispenser. Close the dishwasher's door and press the "On/Off" button. Press the "3 in 1" function button, the correspondent indicator light illuminates. Remember that if this function is selected, it will remain active also for the following programmes, until it will be deactivated by pressing the "3 in 1" function button (indicator light off). Select the required washing programme, after about 3 seconds the programme will start automatically. Once the programme is running, the "3 in 1" function can NO longer be changed. If you want to exclude the "3 in 1" function you have to cancel the programme setting (see "To cancel a washing programme in progress") and then deactivate the "3 in 1" function by pressing the "3 in 1" button. In this case you have to set a washing programme again. With the use of "3 in 1" function, the cycle durations given in the "Washing programmes" chart may change. 29 Operating instructions NOTE: if the drying results are not satisfactory it is possible to activate only the rinse aid dispenser. [. . . ] - A water inlet hose with safety valve must only be replaced by a specialist or by the consumer services department. - Place the water inlet hose in such a way that it is never higher than the bottom edge of the safety valve. 44 Installation instructions Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. [. . . ]