User manual AEG-ELECTROLUX F45011M0

[. . . ] Along with a wide range of accessories designed and built to the high quality standards you would expect, from specialist cookware to cutlery baskets, from bottle holders to delicate laundry bags. The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. Before the installation and use, read this manual carefully: · For your safety and the safety of your property. Always keep these instructions with the appliance also if you move or give it to a different person. [. . . ] The appliance must be in setting mode for these operations: · One or more phase indicator lights come on. One or more phase indicator lights come on. Use of the appliance ­ It is necessary to cancel the programme or the delay start to go back to the setting mode (refer to 'Select and start a washing programme'). Be sure that the set level of the water softener agrees with the water hardness in your area. Fill the salt container with dishwasher salt. Fill the rinse aid dispenser with rinse aid. Load cutlery and dishes into the appliance. Set the correct washing programme for the type of load and soil. Fill the detergent dispenser with the correct quantity of detergent. If you use the combi detergent tablets ('3 in 1', '4 in 1', '5 in 1'), use the multitab function (refer to 'Multitab function'). These minerals and salts can cause damage to the appliance. Do these steps to fill the rinse aid dispenser: 1. Fill the rinse aid dispenser 4 with rinse aid. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. Press the lid until it locks into position. You can set the rinse aid dosage between position 1 (lowest dosage) and position 6 (highest dosage). Some types of tablets can contain other agents. Be sure that these tablets are applicable for the water hardness in your area (refer to the instructions on the packaging of the products). The programme duration can increase if you use the multitab function. activate the multitab function before the start of a washing programme. You cannot activate the function when a washing programme operates. ­ When you set the multitab function, it stays on until you deactivate it. [. . . ] The washing programme was For better drying results, keep without a drying phase or the door ajar for some minutes. Turn the programme knob counterclockwise until the programme marker is aligned with the first washing programme on the control panel. Release the Multitab button when the display shows the set level of the water softener. Turn the programme knob counterclockwise until the programme marker is aligned with the second washing programme on the control panel. [. . . ]