User manual AEG-ELECTROLUX F50777

[. . . ] 152950 34/0en 15-02-2006 9:22 Pagina 1 FAVORIT 50777 Dishwasher Instruction book PERFEKT IN FORM UND FUNKTION 152950 34/0en 15-02-2006 9:22 Pagina 2 Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass it on to any subsequent owner of the appliance. The following symbols are used in the text: Safety instructions Warning!Notes that concern your personal safety. [. . . ] Adjust the water hardness setting according to the hardness of the water in your area. Adjust the rinse aid dosage. q q NOTE: When using 4 in 1 detergents that integrate also anti-glass corrosion agent into "3 in 1" formula, please follow the same instruction as given for "3 in 1" detergents above. 26 152950 34/0en 15-02-2006 9:23 Pagina 27 Operating instructions Washing programmes Cycle description Programme Type of load Degree of soil Main wash Pre-rinse Consumption values2 Duration (minutes) Energy (kWh) AUTOMATIC Crockery and cutlery Normal soil ····· 1/2x 92 1, 1 12 115 1, 5 25 30 MIN Crockery and cutlery Light soil -·-·· · · 2x · · ····· 30 0, 8 INTENSIV CARE 70° Crockery, cutlery, pots and pans Heavy soil 120 1, 7 23 130 1, 9 25 ECO 50° 1 Crockery and cutlery Any. Partial load (to be completed later in the day) Normal soil 160 1, 05 15 (Rinse and Hold) This programme does not require the use of detergent ·---- 12 0, 1 (1) Testing programme for EN 50242 (see "Hints for Test Centres). This programme, developed for the use of detergents with enzymes, allows you to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°C programmes and conventional detergents. To compensate the lower temperature, the duration of washing and drying have been extended. (2) The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply. "AUTOMATIC" washing programme During the "AUTOMATIC" washing programme the amount of soil on the dishes is determined by how cloudy the water is. If the appliance is partially loaded and the dishes lightly soiled, the "prewash", "main wash", and "rinse" phases of the programme are shorter and the water consumption level is lower. If the appliance is fully loaded and the dishes heavily soiled, the "prewash"", main wash", and "rinse" phases of the programme are longer and the water consumption level is higher. For this reason the programme duration, water and energy consumption levels can vary within the stated range for AUTOMATIC programme (see "Washing programmes chart"). During the "AUTOMATIC" programme the temperature of the main wash water is also automatically adjusted between 50°C and 65°C depending on the amount of soil on the dishes. Water (litres) 9 4 Intermediate Final rinse Drying 27 152950 34/0en 15-02-2006 9:23 Pagina 28 Operating instructions Starting a washing programme 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely 2. Press the On/Off button The On/Off indicator light illuminates. 5. Setting and starting the programme To select a programme, press the button of the programme you wish to select, (see "Washing programmes" chart), the indicator light of the button illuminates and in the digital display will appear, flashing, the running time of the programme that has been set (in minutes). After about 3 seconds from the last pressure of a button the programme starts automatically. In the digital display the running time of the programme is no longer flashing. Setting and starting the programme with the delay start The setting of the delay start occurs before selecting the programme Press the delay start button until the flashing number of the hours for the delay start will appear in the digital display (from 1h to 19h). Select a washing programme (see "Washing programmes" chart). In the digital display will appear, for a moment, the running time of the programme and then again appears the selected delay start time. As soon as the number of hours is displayed without flashing, the countdown for the delay start is active. The countdown will decrease with steps of 1 hour. 28 152950 34/0en 15-02-2006 9:23 Pagina 29 Operating instructions The opening of the door during the countdown will not modify the delay start. Once the delay start has elapsed the programme will start automatically. Note: it is possible to select a washing programme and the delay start also with the door slightly opened. In this case the start of the programme or of the countdown will occur after the closure of the door. [. . . ] - A water inlet hose with safety valve must only be replaced by a specialist or by the Service Force Centre. - Place the water inlet hose in such a way that it is never higher than the bottom edge of the safety valve. 44 152950 34/0en 15-02-2006 9:23 Pagina 45 Installation instructions Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. [. . . ]