User manual AEG-ELECTROLUX F50800W

[. . . ] ÖKO_FAVORIT 50800 Dishwasher User Instructions Dear customer, Please read these user instructions carefully. Above all please observe the safety instructions on the first few pages ofthese user instructions!Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. 1 0 The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance. [. . . ] The various stages in the wash programme have different sounds because the dishes are washed more intensely for short periods during certain stages of the wash programme to improve cleaning. The consumption figures were recorded under standard conditions. They are dependent on the loading of the dish racks. Variations are therefore possible in practice. Testprogramme for Test Institutes 22 Operating instructions Start the wash programme 0 1. Check that the dishes and cutlery are loaded into the dishwasher in such a manner that the spray arms are free to rotate. The ON/OFF button indicator illuminates. Press the programme button for the desired programme (see "Programme Table"). The selected programme begins after around 6 seconds. The time remaining until the end of the programme is displayed on the multi-display, the time calculated is dependent on the load in the dish racks. With automatic programme adjustment this residual time count can be stopped or corrected if necessary (load quantity, degree of dirtiness, etc. ) using the dishwasher control. 3 If fault messages are displayed on the multi-display after the start of the programme, please read the "What to do, if. . . " section. Changing/Interrupting/Cancelling the Wash Programme 3 Only change or interrupt a wash programme in progress if it is absolutely necessary to do so. When the appliance is closed again, the air that has entered is heated and expands significantly. As result water may penetrate into the base of the appliance and trigger the leak prevention system. Changing the wash programme If you want to change the wash programme within 6 seconds of making a programme selection, briefly press the button for the new wash programme. If you want to change the wash programme at a later point in time, use the following procedure: 0 1. Press the button for the new wash programme and hold it pressed. The indicators for both programmes now flash. After a few seconds only the indicator for the new programme flashes. Release the programme button, the new programme is now running. 3 23 Operating instructions Interrupting the wash programme by opening the door of the dishwasher Hot steam may escape from the appliance when opening the door. The indicator for the programme that is currently running extinguishes. The wash programme continues. 1 Cancelling the wash programme 0 1. Press the button for the current wash programme and hold it pressed. [. . . ] Box 1 15 29 Jeddah Tel. : 6606852 Slovenia Electrolux Slovenia D. O. O. 132 1000 Ljubljana Tel. : 61 1234 137 Fax: 61 1234 238 Malaysia Israel Arzbergh Engineering Electricity & Electronic No. 49A/B, Jalan Petaling Services-Evis LTD. Raanana, Industrial area 43654 4600 Petaling Jaya Tel. : 3 795 1084 Tel: 972-9-7448118 Fax: 3 795 1082 Fax: 972-9-7603618 e-mail:evis@evis. co. il Japan Electrolux Japan Ltd. [. . . ]