User manual AEG-ELECTROLUX F60830W

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfect ly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] If you want to use 3in1 detergents, check whether these detergents are suitable for your water hardness. (Follow manufacturer's instructions!) If your water hardness is higher than that recommended by the manufacturer but you would nevertheless like to use 3in1 detergent, proceed as follows: With the 3in1 function selected, set the water softener one hardness setting lower than when rinsing without 3in1 detergent. Fill up the dispenser (if this is empty) with special salt. The dishwasher remembers the two different settings of the degree of hardness for rinsing with and without 3in1 function. The button indicator lights up: 3in1 function is selected. Before the start of the dishwashing cycle put 3in1 detergent in the detergent dispenser. As the rinse aid inflow is automatically switched off when the 3in1 function is activated, it may come about because of the different quality standards in the 3in1 detergent, that the dishes do not dry sufficiently. If this happens, proceed as follows (see section "Adding rinse aid"): Fill up the dispenser (if this is empty) with rinse aid. Set rinse aid dosage to "2" mechanically. Activate rinse aid inflow. 3 3 In daily use 25 If you do not want to use 3in1 products any more If you want to stop using 3in1 products, please do the following: Deactivate the 3in1 function. Fill up the dispensers for salt and rinse aid again. The LED indicators of all the programme buttons that can be selected light up. The dishwashing cycle has been cancelled. If you want to start a new cycle, check whether there is any detergent in the dis penser. Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. 3 30 In daily use Setting the Delay Timer 3 With the delay timer you can delay the start of a dishwashing cycle for between 1 and 19 hours. Press the Delay Timer button repeatedly until the multi display shows the de sired time delay, for example 12h, if the cycle is to start in 12 hours. The Delay Timer indicator is illuminated. The time remaining to the start of the cycle is continuously displayed (e. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. Cancelling the time delay: Press the Delay Timer button repeatedly until the length of the selected cycle appears in the multi display. The selected dishwashing cycle will begin immedi ately. [. . . ] Extension hoses Extension hoses are available from your dealer or from our Customer Care Depart ment. To ensure that the function of the appliance is not impeded, the internal di ameter of extension hoses must be 19 mm. Extension hoses must not be laid more than a maximum distance of 4 metres horizontally; the maximum permitted height for the connection for the drain hose is then 85 cm. Sink outlet connection The outlet of the drain hose ( 19 mm) fits all commonly available sink outlet types. The outer diameter of the sink outlet connection must be at least 15 mm. [. . . ]