User manual AEG-ELECTROLUX F64080I-A

[. . . ] Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information Your dishwasher has the new washing system "IMPULSE WASHING". With this dishwashing system the motor speed and spray pressure are varied during the wash cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 152958 33/0en 9-02-2005 12:50 Pagina 3 Contents CONTENTS Operating instructions Safety instructions Disposal Economical and ecological dishwashing Description of the appliance The control panel Prior to using for the first time The water softener Filling with dishwasher salt Rinse aid In daily use Loading cutlery and dishes The lower basket The cutlery basket The upper basket Adjusting the height of the upper basket Use of detergent Different kinds of detergent Washing programmes Starting a washing programme Maintenance and cleaning Cleaning the filters What to do, when. . . [. . . ] 25 152958 33/0en 9-02-2005 12:51 Pagina 26 Operating instructions Use of "3 in 1" combi detergents General advice These products are detergents with integrated and combined detergent/rinse-aid and salt functions. Before using these products you should first check that the water hardness in your supply is compatible with the use of these products as per the detergent manufacturers (on the product packaging). These products should be strictly used according to the detergent manufacturers instructions. If you encounter problems when using 3 in 1 products for the first time then please contact the detergent manufacturers care line (the telephone number is given on the product packaging). Special advice When using combination 3 in 1 products, we recommend the use of the "3 in 1" function. If you decide to turn back to the use of the standard detergent system we advise that you: q q q Refill both the salt container and rinse aid dispenser. Switch the water hardness setting to the highest possible position and run from 1 to 3 normal washing programmes without a load. Readjust the water hardness setting again according to the hardness of the water in your area. 26 152958 33/0en 9-02-2005 12:51 Pagina 27 Operating instructions Washing programmes Cycle description Programme Type of load Degree of soil Main wash Pre-rinse Consumption values3 Duration (minutes) Energy (kWh) AUTOMATIC Crockery and cutlery Normal soil ····· 1/2x 92 1, 10 12 bis bis bis 115 1, 50 25 30 MIN 1 Crockery and cutlery Fresh soil -·-·· · · 2x · · ····· 30 0, 80 9 INTENSIV CARE 70° Crockery, cutlery, pots and pans Heavy soil 120 1, 70 23 bis bis bis 130 1, 90 25 155 0, 95 13 bis bis bis 165 1, 05 15 ECO 50° 2 Crockery and cutlery Normal soil (1) Ideal for washing crockery and cutlery of breakfast and dinner (fresh soil). This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. (2) Testing programme for EN 50242 (see "Hints for Test Centres). This programme, developed for the use of detergents with enzymes, allows you to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°C programmes and conventional detergents. To compensate the lower temperature, the duration of washing and drying have been extended. Until this moment it is possible to change or modify the setting made. 6. To interrupt or cancel a washing programme in progress Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary Attention!Hot steam may escape when the door is opened. Open the door carefully. To interrupt a washing programme a) Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. b) Press the On/Off button, in this case all the indicator lights turn off. Press the On/Off button again; the programme will start from the point at which it was interrupted. 29 152958 33/0en 9-02-2005 12:51 Pagina 30 Operating instructions To cancel a washing programme To cancel a washing programme you have to reset the dishwasher; press simultaneously the function buttons 2 and 3 for about 2 seconds, the indicator light of the button corresponding to the running programme starts flashing for about 2 seconds. After about 2 seconds the indicator lights of all the programme buttons will illuminate indicating that the running programme has been cancelled and that the machine has returned to setting mode. It is now possible to select and start a new washing programme. If a new washing programme will be selected, check that there is detergent in the detergent dispenser. 7. To cancel a "delay start" To cancel a delay start you have to reset the dishwasher; follow the same instructions given in "To cancel a washing programme". [. . . ] - A water inlet hose with safety valve must only be replaced by a specialist or by the consumer services department. - Place the water inlet hose in such a way that it is never higher than the bottom edge of the safety valve. 44 152958 33/0en 9-02-2005 12:51 Pagina 45 Installation instructions Water outlet hose connection The end of the drain hose can be connected in the following ways: 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. [. . . ]