User manual AEG-ELECTROLUX F64450IB

[. . . ] FAVORIT 64450 I Geschirrspülautomat Dishwasher Gebrauchsanweisung Operating instructions Dear customer! Please read these user instructions carefully. Above all please observe the safety instructions on the first few pages of these user instructions!Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. [. . . ] For all programmes with prewash; place a portion of a further tablet on the lid of the detergent dispenser. At the end of any washing programme the lid is always open, ready for the next wash. Remember that insufficient quantities of detergent will produce poor washing results whereas an excessive amount of detergent does not improve washing results and is also wasteful. Using no more than correct amount of detergent also contributes to reducing pollution. Compact detergents with enzymes In these compact powders the environmentally unfriendly components have been replaced by natural enzymes and other more biodegradable substances. The enzymes deploy their full dirt dissolving power at a temperature as low as 50°C. By choosing the "50°C" programmes you can therefore achieve the same cleaning results that would otherwise be achievable only with 65°C programmes and conventional detergents. 57 Washing programmes Type of soil and type of load Heavy soil. Crockery, cutlery, pots and pans Required push buttons Programme Intensive 70°C On/Off + INTENSIV 70° On/Off + 30 MIN On/Off + NORMAL 50° * 30 Minutes Fresh soil. Crockery and cutlery ** Normal 50°C Normal soil. Crockery and cutlery *** Eco 50°C Normal soil. Crockery and cutlery On/Off + ECO 50° * Ideal for washing crockery and cutlery of breakfast and dinner (fresh soil) . Characterised by a duration of about 30 minutes and a washing temperature of 60°C. The time value is approximate and depends on the pressure and the temperature of the water and also by the variations of the power supply. This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. ** In this programme the appliance is fitted with the special device SENSORLOGIC. This device allows the dishwasher to automatically individuate if the baskets are full loaded or not and consequently reduce the washing temperature and time duration of the programme. This allows to obtain a saving in energy and time. Testing programme for EN 50242 (see "Hints for Test Centres"). This programme, developed for the use of detergents with enzymes, allows to achieve, with reduced consumption of energy the same cleaning results that would otherwise be obtained only with the 65°C programmes and conventional detergents. To compensate the lower temperature, the duration of the programme has been prolonged. *** 58 Cycle description Hot prewash Main wash up to 70°C 2 cold rinses 1 warm rinse Turbo drying Main wash up to 60°C 1 warm rinse Cold prewash Main wash up to 50°C 1 cold rinse 1 warm rinse Turbo drying Cold prewash Main wash up to 50°C 1 cold rinse 1 warm rinse Turbo drying Recommended quantity of detergent Wash Prewash Approximate values * Programme duration in minutes Water Energy consumption consumption in litres in kWh 15 g 10 g 94 ÷ 104 1. 89 18 20 g / 25 ÷ 35 0. 79 9 20 g 5g 79 ÷ 89 0. 99 14 20 g 5g 121 ÷ 131 0. 80 14 Programme NORMAL 50°C with SENSORLOGIC 75 ÷ 85 0. 91 14 * The times and consumption are intended as a guide and depend on the pressure and temperature of the water and also by the variations of the power supply. 59 Operating instructions 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 2. Press the On/Off push button The On/Off indicator light will come on. 3. Check that there is rinse aid and salt The corresponding indicator lights will illuminate if refilling is necessary. 4. Load the dishes Remove any scraps of food. [. . . ] Your local Water Authority will advise you on the average mains pressure in your area. Avoid bends or kinks in the hose which could prevent or slow down the water supply. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. This will prevent deposits of sand or rust clogging the inlet hose filter. [. . . ]