User manual AEG-ELECTROLUX F65410W0P

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] Once the programme is running, the "Multi-Tab function " can NO longer be changed. If you want to exclude the "Multi-Tab function " you have to cancel the programme setting and then deactivate the "Multi-Tab function ". In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the Multi-Tab function Simultaneously press and hold the two Multi-Tab buttons (D and E), until the "Multi-Tab function" indicator light illuminates. To deactivate the function press the same buttons again until the "Multi-Tab function" indicator light turns off. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. · The activation/deactivation of the rinse aid dispenser can only be possible with the "Multi-Tab function" active. Activation/deactivation of the rinse aid dispenser 1. Press simultaneously buttons B and C, until the lights of buttons A , B, and C start flashing. Press button B, the lights of buttons A and C turn off while the light of button B goes on flashing. The digital display indicates the current setting: = Rinse aid dispenser deactivated. 5. start of the selected washing programme can be delayed for between 1 and 19 hours. Close the dishwasher door, the countdown starts automatically. The countdown will decrease with steps of 1 hour. The opening of the door will interrupt the countdown. Close the door; the countdown will continue from the point at which it was interrupted. Once the delay start has elapsed the programme will start automatically. Once the washing programme has started, a point-shaped optical signal appears on the floor beneath the dishwasher's door. This optical signal will remain illuminated for all the duration of the washing programme. If the appliance has been installed higher up with a furniture door mounted flush, the optical signal will be no longer visible. Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Hot steam may escape when the door is opened. Open the door carefully. Cancelling a delay start or a washing programme in progress · Simultaneously press and hold the two programme buttons positioned over the word RESET , until all the programme button lights will illuminate. [. . . ] To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. The waste connection must be at a maximum height of 60 cm from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher. Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. [. . . ]