User manual AEG-ELECTROLUX F77022W0P

[. . . ] Along with a wide range of accessories designed and built to the high quality standards you would expect, from specialist cookware to cutlery baskets, from bottle holders to delicate laundry bags. The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. Before the installation and use, read this manual carefully: · For your safety and the safety of your property. Always keep these instructions with the appliance also if you move or give it to a different person. [. . . ] It comes on when it is necessary to fill the rinse aid dispenser. It comes on when it is necessary to fill the salt container. 1) After you fill the container, the salt indicator can stay on for some hours. This does not have an unwanted effect on the operation of the appliance. It comes on when you activate the delay start. It comes on when the door is open or not closed correctly. 1) When the salt container and/or the rinse aid dispenser are empty, the related indicators do not come on while a washing programme operates. After ten minutes from the end of the washing programme, the AUTO OFF function automatically deactivates the appliance. This helps to decrease energy consumption. This guide helps you in the selection of the washing programme. Press this button again and again until the indicator of the washing programme comes on. obey the instructions on the detergent packaging. If the washing programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. If you use the detergent tablets, put the tablet in the detergent dispenser 1 . Press the lid until it locks into position. Use long washing programmes when you use the detergent tablets. These cannot fully dissolve with short washing programmes and can decrease the washing results. Rinse aid makes it possible to dry the dishes without streaks and stains. the rinse aid dispenser automatically adds rinse aid during the last rinsing phase. Do these steps to fill the rinse aid dispenser: 1. Fill the rinse aid dispenser 3 with rinse aid. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during the washing programme. [. . . ] Put the two parts of the filter (A) together and push. Make sure that they assemble correctly in each other. Put the filter (B) to its initial position. Make sure that it assembles correctly in the two guides (C). [. . . ]