User manual AEG-ELECTROLUX F77028M0P

[. . . ] The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has been designed. Never leave high naked flames under the hood when it is in operation. [. . . ] Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period (Fire hazard), Grease filters Z The filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. - Activated charcoal filter W These filters are not washable and cannot be regenerated, and must be replaced approximately every 4 months of operation, or more frequently with heavy usage. Clean the on the product or on its packaging indicates that this product may not be treated as household hood using a damp cloth and a neutral liquid detergent. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. After 200 hours operation the Led flashes to indicate saturation of the Activated Charcoal Filters. Manages Lighting Intensity:0--L1--L2--L3-LMax Filter ResetResets the Filter Saturation alarm when the button is touched with the motor and lighting turned off. When this button is pressed and held for 4 seconds(Motor Off + Lights Off), in the absence of other alarms, the Led will light up for: 4 seconds to indicate that the Activated Charcoal Filter Alarm has been activated 2 seconds to indicate that the Activated Charcoal Filter Alarm has been deactivated After connecting the hood to the mains, the commands are activated after 4seconds. When the Hood is switched off, none of the functions is displayed, and only the normal lettering on the control panel is visible. All the rest will light up (intensity 50%) when button A is touched. The controls are activated by touching the selected function, which will light up more brightly (intensity 100%) with respect to the other hood functions (intensity 50%). When no commands are given for at least 10 seconds, only the selected functions will be lighted (Intensity 100%) and all the rest will turn off (Intensity 50%). After 7 hours in operation, if no further commands are given the hood will switch off (Motor Off + Lights Off), from here you can touch for activated the function, and the next touch you can select the desired function. It is possible to activate one of the hood functions (Speed and Lighting) not just by touching the control panel, but also by placing a finger on the panel and sliding it towards the chosen function without lifting it off. [. . . ] It is possible to activate one of the hood functions (Speed and Lighting) not just by touching the control panel, but also by placing a finger on the panel and sliding it towards the chosen function without lifting it off. If the motor and lights are turned off, by setting them to zero, all the command LEDs will remain on at 50%, and if no further commands are given in the next 10 seconds, then all the LEDs will be turned off with the exception of the "0" LEDs, which will remain on for a further 15 minutes. Two options are available: · Turn the hood off using the hood on/ off button · Remove power for 10 seconds and then reconnect it. [. . . ]