User manual AEG-ELECTROLUX F84470VI

[. . . ] FAVORIT 84470 VI Dishwasher User information PERFEKT IN FORM UND FUNKTION Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass it on to any subsequent owner of the appliance. The following symbols are used in the text: Safety instructions Warning!Notes that concern your personal safety. [. . . ] Place just the detergent in the detergent dispenser. If you want to stop using 3 in 1 products, please do the following: · Fill up the dispensers for salt and rinse aid. · Switch the water softener to the highest setting and perform up to three normal cycles without loading any dishes. · Then set the water softener to the water hardness in your area. 18 Operating instructions Selecting the programme (Programme Table) Programme sequence Cycle Suitable for Type of soiling Pre-rinse Consumption values1 Length (minutes) Energy (kWh) AUTOMATIC 2 Dinner service and cookware Dishes excluding saucepans normally soiled, dried-on food remains just used, lightly to normally soiled heavily soiled, dried on food remains, in particular protein and starch ····· -·-·· · · 2x · · 80 0, 80 12 bis bis bis 105 1, 20 21 25 0, 70 7 bis bis bis 30 0, 80 8 113 1, 60 19 bis bis bis 127 1, 80 21 30 MIN. INTENSIVE CARE 70° Dinner service and cookware Dinner service and cookware temperaturesensitive crockery ECO 50° 3 normally soiled ····· 160 0, 75 12 bis bis bis 170 0, 80 13 (1) The consumption values were obtained under standardised conditions. They depend on how full the baskets for the dishes are. Variations are therefore possible in practice. (2) When using this programme the degree of water clouding determines the amount of soiling on the dishes. The length of the programme and water and energy consumption can vary greatly ­ depending upon the load and how dirty the dishes are. Depending upon the soiling, the temperature of the water will be automatically adjusted to between 50°C and 65°C. (3) Test programme for Test Institutes. Water (litres) Intermediate Main wash Final rinse Drying 19 Operating instructions Starting a programme 1. Check that the dishes and cutlery are stacked in the dishwasher in such a way that the spray arms are free to rotate. The LED indicators for all the buttons in the control panel that are now able to be selected will become illuminated. Press the relevant button for the cycle required (see "Programme Table"). The cycle display will become illuminated. The remaining time for the cycle will be shown in the multi-display. The remaining time for the cycle is adjusted according to amount of dishes, degree of soiling, etc. A point-shaped optical signal appears on the floor beneath the appliance's door. The punctiform light signal is not dangerous as it is not a laser light. If the appliance has been installed higher up with a forniture door mounted flush, the optical signal will no longer be visible. If an error message is displayed in the multi-display and/or if an acoustic error message can be heard after the cycle has begun, please read the section "What to do when. . . ". Interrupting or cancelling a programme Only interrupt a programme that is in progress if it is absolutely necessary. After the appliance has been closed again, the air that has entered will be heated significantly and expand. As a result, water may collect in the base of the appliance and trigger the antiflood system. [. . . ] This will prevent waste water from the sink running into the machine. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. [. . . ]