User manual AEG-ELECTROLUX F86080VI

[. . . ] FAVORIT 86080 Vi User manual Dishwasher 2 Dear Customer Thank you for choosing one of our high quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best per formance and control indeed we are setting the highest standards of excel lence. In addition to this you find environmental and energy saving aspects as an inte gral part of our products. [. . . ] A light signal in the form of a dot appears at floor level. If the dishwasher is built in at high level with flush fitting cupboard doors, the light signal cannot be seen. The dot shaped light signal is not dangerous. (It is not a laser. ) It lights up while a dishwasher cycle is running and goes out when the cycle ends. Interrupting or aborting a dishwashing cycle 1 Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary. Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 2 and 3 and keep them pressed. The LED indicators of all the programme buttons that can be selected light up. The dishwashing cycle has been cancelled. If you want to start a new cycle, check whether there is any detergent in the dis penser. 28 In daily use Setting the Delay Timer 3 With the delay timer you can delay the start of a dishwashing cycle for between 1 and 19 hours. Press the Delay Timer button repeatedly until the multi display shows the de sired time delay, for example 12h, if the cycle is to start in 12 hours. The Delay Timer indicator is illuminated. The time remaining to the start of the cycle is continuously displayed (e. To change the time delay: As long as the cycle has not yet started, you can still change the setting by pressing the DELAY TIMER button. Cancelling the time delay: Press the Delay Timer button repeatedly until the length of the selected cycle appears in the multi display. The selected dishwashing cycle will begin immedi ately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re set the time delay, lastly select the new dishwashing cycle. In daily use 29 Switching off the dishwasher When the dishwasher cycle has ended, the dot shaped light signal below the door of the appliance goes out. If the acoustic signal has been enabled, a continuous tone will sound for approx. 15 seconds at the end of the dishwashing cycle. If the dishwasher door is not opened, the acoustic signal will repeat after 3 min utes and again after 6 minutes. With some dishwashing cycles, the drying fan continues to run even after the end of the cycle. Therefore leave the dishes to cool for about 15 minutes before removing them. [. . . ] In the event of legally admitted liability, compensation will not exceed the purchase price paid for the appliance. These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation in structions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and en vironmental conditions. For appliances purchased abroad, the user must first ensure that they meet the 44 Guarantee/Customer Service qualifications required in Belgium. [. . . ]