User manual AEG-ELECTROLUX F88040IMP

[. . . ] And please pass it to any future owner of the appliance. We wish you much joy with your new appliance. Contents Operating instructions Safety information Correct use General safety Child safety Installation Product description Control panel Cancel button Programme selection buttons NIGHT CYCLE button Delay start button Digital display Function buttons Setting mode Use of the appliance Setting the water softener Manual adjustment Electronic adjustment Use of dishwasher salt Use of rinse aid Adjusting the rinse aid dosage Loading cutlery and dishes Helpful hints and tips Lower basket Cutlery basket Upper basket Adjustment of the height of the upper basket Use of detergent 3 3 3 3 3 4 4 5 6 6 6 6 6 7 7 7 7 8 8 9 9 10 11 11 11 12 13 13 14 Multitab function 15 Washing programmes 16 Setting and starting a washing programme 18 Cancelling a washing programme 18 Interrupting a washing programme 18 Setting and starting a washing programme with delay start 19 Cancelling a delay start 19 End of the washing programme 19 Standby mode 19 Removing the load 19 Care and cleaning 20 Cleaning the filters 20 External cleaning 21 Frost precautions 21 What to do if. . . 21 Technical data Installation instructions Installation Attaching the appliance to the adjacent units Adjusting the level of the appliance Water connection Water inlet hose Water drain hose Electrical connection Environment concerns 23 23 23 24 24 24 24 25 26 26 Subject to change without notice Safety information 3 Operating instructions Safety information For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. [. . . ] Refer to the instructions from the manufacturer. When you set the multitab function, it stays on until you deactivate it. The multitab function stops automatically the flow of rinse aid and salt. The rinse aid indicator light and salt indicator light are deactivated. The programme duration can increase if you use the multitab function. Activate or deactivate the multitab function before the start of a washing programme. You cannot activate or deactivate the multitab function when the programme operates. Cancel the washing programme, then set the programme again. 16 Washing programmes To activate the multitab function: · Press the multitab button. To deactivate the multitab function: · Press the multitab button. Do these steps if the drying results are not satisfactory: 1. Fill the rinse aid dispenser with rinse aid. The washing programme only starts after you close the door. Until then it is possible to modify the settings. Do these steps to set and start a washing programme: 1. Make sure that the appliance is in setting mode. Refer to the chapter 'Washing programmes'. ­ The related programme indicator light comes on. ­ All other programme indicator lights go off. ­ The digital display shows in flashing the programme duration. If necessary, set the Night Cycle programme. Press the Night Cycle button, the related indicator light comes on. The washing programme starts automatically. [. . . ] This prevents that the waste water from the sink goes back into the appliance. Connect the water drain hose to a stand pipe with vent-hole (minimum internal diameter 4 cm). The waste connection must be at a maximum height of 60 cm from the bottom of the dishwasher. Make sure that the drain hose is not bent or squashed to prevent that the water drains does not drain correctly. [. . . ]