User manual AEG-ELECTROLUX F88400IM0P

[. . . ] FAVORIT 88400 I EN DISHWASHER USER MANUAL 2 www. aeg. com CONTENTS 4 6 7 8 10 11 14 17 18 20 SAFETY INSTRUCTIONS PRODUCT DESCRIPTION CONTROL PANEL PROGRAMMES OPTIONS BEFORE FIRST USE DAILY USE CARE AND CLEANING TROUBLESHOOTING TECHNICAL INFORMATION ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. [. . . ] Refer to the table to adjust the water softener to the right level. It makes sure that the water softener uses the correct quantity of dishwasher salt and water. You must adjust the water softener manually and electronically. Water hardness German degrees (°dH) 51 - 70 43 - 50 37 - 42 29 - 36 23 - 28 19 - 22 15 - 18 11 - 14 4 - 10 <4 French degrees (°fH) 91 - 125 76 - 90 65 - 75 51 - 64 40 - 50 33 - 39 26 - 32 19 - 25 7 - 18 <7 mmol/l Clarke degrees 64 - 88 53 - 63 46 - 52 36 - 45 28 - 35 23 - 27 18 - 22 13 - 17 5 - 12 <5 Water softener adjustment Manual Electronic 10 9 8 7 6 51) 4 3 2 12) 9. 1 - 12. 5 7. 6 - 9. 0 6. 5 - 7. 5 5. 1 - 6. 4 4. 0 - 5. 0 3. 3 - 3. 9 2. 6 - 3. 2 1. 9 - 2. 5 0. 7 - 1. 8 < 0. 7 2 1) 2 1) 21) 21) 21) 21) 1 1 1 12) 1) Factory position. 2) Do not use salt at this level. 12 www. aeg. com Manual adjustment Turn the water hardness dial to the position 1 or 2. Electronic adjustment 1. Press the on/off button to activate the appliance. Make sure that the appliance is in setting mode. Refer to ‘SETTING AND STARTING A PROGRAMME’. Press and hold Delay and Start at the same time until the indicators (A), (B) and (C) flash. 4. • The indicators (B) and (C) go off. • The indicator (A) continues to flash. • The display shows the setting of the = levwater softener. Press Program again and again to change the setting. Deactivate the appliance to confirm. FILLING THE SALT CONTAINER CAUTION!Other products can cause damage to the appliance. Water and salt can come out from the salt container when you fill it. To prevent it, after you fill the salt container, start a programme. 1. • Make sure that the spray arms can move freely before you start a programme. LOADING THE BASKETS Refer to the supplied leaflet with examples of the load of the baskets. • Only use the appliance to wash items that are dishwasher-safe. USING THE DETERGENT A B 1. - CAUTION!Use only detergents for dishwashers. 30 20 + MAX 4 32 2. 5. Press the release button (B) to open the lid (C). Put the detergent in the compartment (A) . If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. [. . . ] Make sure that you add detergent in the dispenser before you start a programme. Make sure that there is dishwasher salt in the salt container. Make sure that the set level of the water softener agrees with the water hardness in your area. Decrease the released quantity of rinse aid . The quantity of detergent was not sufficient. There was no detergent in the detergent dispenser. [. . . ]