User manual AEG-ELECTROLUX FACTIVEAA

[. . . ] It is imperative that these instructions are observed. This symbol or numbered instruction steps lead you step by step through the operation of the appliance. Next to this symbol you receive additional information and practical tips on using the appliance. Tips and instructions for the economical and environmentally friendly use of the appliance are marked with a clover leaf. [. . . ] Only use rinse aid specifically designed for domestic dishwashers. Never fill the rinse aid dispenser with any other substance (e. g. vinegar concentrate or dishwasher detergent) as this would damage the appliance. The rinse aid dispenser is on the inside of the dishwasher door. Open the lid to the dispenser by pressing the lid catch towards the compartment and lift the lid. Fill up with rinse aid; do not overfill. Wipe off any spillage carefully to prevent excessive foaming during the next wash programme. Close the lid and press until it locks again. Fill with rinse aid: When the indicator light on the control panel is lit. Adjusting rinse aid dosing The dispenser holds about 150 ml. 60 wash cycles, depending on the dosage setting. Adjust the dosage setting according to the hardness of the water. Open the door carefully when the dishwasher is running, since hot steam may escape. Cancelling the programme 1. Press and hold in the combination buttons, the machine goes to starting position and all programme indicator lamps are lit. The programme is now cancelled and a new programme can be selected. If you switch the dishwasher off with the On/Off button, the selected programme is not finished, it is only disrupted. When you start the dishwasher again, the programme will continue. Pause function With the paus function the programme can be temporarily disrupted for a short period of time. When you want the programme to continue again, you press the On/Off button. The programme should not be paused for any longer than necessary, because the water inside the dishwasher has cooled down and must be heated again which increases the power consumption. 17 Instruction book Cancelling the drying phase In case you do not want to wait until the drying phase is completed, you can cancel it. The drying phase is cancelled. Setting the delay start The programme start can be delayed between 1 and 19 hours. Press the delay start button repeatedly, until the required delay shows on the display. Indicator lamp for the delay start button is lit. Press the button for the required programme. [. . . ] To function properly, make sure that the appliance is level. Its height can be adjusted with the adjustable feets (5 mm each). See the illustration for built-in measurements. 24 Position- and connection instructions Water inlet The dishwasher is equipped with safety features which are to prevent the water from going back to the fresh water system. These features are according to current water technical safety regulations. [. . . ]