User manual AEG-ELECTROLUX FAV 6050 I W

[. . . ] It is imperative that these instructions are observed. This symbol or numbered instruction steps lead you step for step through the operation of the appliance. Next to this symbol you receive additional information and practical tips on using the appliance. Tips and instructions for the economical and environmentally conscious use of the appliance are marked with a clover leaf. [. . . ] 5) When the hardness setting is electronically adjusted to 10, the length of the dishwashing cycle may be slightly longer. 25 Operating Instructions Starting a dishwashing cycle 0 1. Check that the dishes and cutlery are stacked in the dishwasher in such a way that the spray arms are free to rotate. The LED in the ON/OFF button will become illuminated. Press the relevant button for the cycle required (see "Cycle Table"). The cycle display will become illuminated. The remaining time for the cycle will be shown in the multi-display. The selected cycle will begin after approximately 3 seconds. 3 3 During the dishwashing cycle, the remaining time shown in the multidisplay may be adjusted according to amount of dishes, degree of soiling, etc. If an error message is displayed in the multi-display after the cycle has begun, please read the section "What to do if . . . ". Changing/interrupting/aborting a dishwashing cycle 3 Only change or interrupt a dishwashing cycle that is in progress if it is absolutely necessary. After the appliance has been closed again, the air that has entered will be heated significantly and expand. As a result, water may collect in the base of the appliance and trigger the antiflood system. Changing a dishwashing cycle If you would like to change the dishwashing cycle in the first 3 seconds after having selected a cycle, briefly press the button for the new dishwashing cycle. The newly selected dishwashing cycle will start automatically following a countdown of the hours set. Load Sensing ­ Sensor Logic If a wash programme is started even though there are only a few dishes in the upper and/or lower rack, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0. 2 kWh of electricity are saved. 28 Operating Instructions Switching Off the Dishwasher Only switch the dishwasher off when the multi-display indicates "0" remaining programme time. The ON/OFF button indicator extinguishes. 1 Hot steam may escape from the appliance when opening the door immediately after the end of the programme. Open the door carefully. Emptying the Dishwasher 3 · Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing them from the appliance. · Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down. · First empty the lower rack, and then the upper rack. By using this procedure you will avoid any water that may be remaining in the upper rack, dripping onto the dishes in the lower rack and leaving water marks. Care and Cleaning 1 Do not under any circumstances use furniture care products or aggressive cleaners. · If necessary, clean the controls only with a soft cloth and pure warm water. [. . . ] A repair under guarantee does not mean that the normal guarantee period will be extended nor that a new guarantee period begins. We give a twelve month guarantee for repairs, limited to the same defect. Except in the event where liability is legally imposed, this declaration of guarantee terms excludes any compensation for damage outside the appliance for which the consumer wishes to assert his rights. In the event of legally admitted liability, compensation will not exceed the purchase price paid for the appliance. [. . . ]