User manual AEG-ELECTROLUX FAV40250I-W

[. . . ] ÖKO_FAVORIT 40250 i Dishwasher User Instructions Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages ofthese user instructions!Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. 1 0 The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance. [. . . ] They are intended as a guide only as variations can occur during normal usage. 20 Operating Instructions Starting the Wash Programme 0 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. Turn the programme selector clockwise to A, or B or C (see "Programme Table"). 1 For interference suppression reasons, only operate the programme selector with the dishwasher switched off. It is also possible that the automated addition of detergent will be triggered. Turn the programme selector to the required programme (see "Programme Table"). The programme selector rotates during the wash programme and indicates the position that has been reached in the programme. If a wash programme has been started even though the tap was closed, turn the programme selector to the I position, open the tap and start the programme again. 1 Changing/Interrupting the Wash Programme 3 Only change or interrupt a wash programme in progress if it is absolutely necessary. Changing the wash programme 0 1. Turn the programme selector to the I position. Power indicator light goes out, wash programme stops. 1 Hot steam may escape when the door is opened. Open dishwasher door and check whether there is still detergent in the container. Turn the programme selector clockwise to A, or B or C (see "Programme Table"). Turn the programme selector to the required programme (see "Programme Table"). Power indicator light illuminates, wash programme starts. 21 Operating Instructions Interrupting the wash programme by opening the door of the dishwasher Hot steam may escape when the door is opened. The wash programme continues. 1 Switching Off the Dishwasher When the wash programme is finished: 0 1. Turn the programme selector to the I position. Power indicator light goes out. 1 Hot steam may escape if the door is opened immediately after the end of the programme. Open the door carefully. Emptying the Dishwasher 3 · The dishes should therefore be allowed to cool down before removing them from the appliance, as hot dishes can be sensitive to knocks. · Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down. · Empty the lower rack first, then the upper rack. This will avoid any water left on the upper rack dripping onto the dishes in the lower rack and causing water spots. Care and Cleaning 1 Do not under any circumstances use furniture care products or aggressive cleaners. · If necessary, clean the controls only with a soft cloth and pure warm water. [. . . ] The guarantee or free replacement includes both labour and materials. Repairs carried out under guarantee do not extend the guarantee period for the appliance. Parts removed during guarantee repairs become the property of AEG. The purchaser´s statutory rights are not affected by this guarantee. [. . . ]