User manual AEG-ELECTROLUX FAV40730

[. . . ] FAVORIT 40730 Dishwasher User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 3 Your dishwasher is fitted with the new "PULSE WASH" dishwashing system. [. . . ] · Empty the lower basket first, then the upper basket. This way you avoid dripping water from the upper basket onto dishes in the lower basket. 22 Care and cleaning 1 Do not use furniture care products or aggressive cleaners. · When necessary, clean the dishwasher's controls with a soft cloth and clean warm water. · Occasionally check the internal dispensers, door seal and water inlet filter (if fitted) for dirt and clean them, if necessary. Cleaning the filters 3 The filters must be regularly checked and cleaned. Dirty filters will spoil the wash results. Open the door and remove the lower basket. Turn the handle about ¼ of a turn anticlockwise (A) and remove the filter system (B). 3. Grasp the grip hole on the fine filter (1) and remove it from the micro-filter (2). Clean all filters thoroughly under running water. 23 1 5. Remove the flat filter (3) from the base of the washing compartment and clean both surfaces thoroughly. Place the fine filter in the micro-filter and fit the two together. Insert the filter system in place and lock it by turning the handle clockwise as far as it will go. Ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without its filters. What to do if. . . Remedying small malfunctions If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault. After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. If the fault is displayed again or if other faults are displayed, please contact the Customer Care Department and inform them of the fault display. 24 Malfunction Possible cause The tap is blocked or furred with lime-scale. The tap is turned off. Remedy Clean tap. Turn the tap on. The programme indicator for the selected dishwashing cycle is flashing, the indicator for the end of the dishwashing cycle is flashing in rhythm 1 short light signal with approx. 3 second pause in-between: (Problems with water inlet) The filter (where present) in Clean the filter in the the threaded hose fitting on threaded hose fitting. Press the button for the dishwashing cycle that has started; then abort the dishwashing cycle (see section: Starting a dishwashing cycle); clean filters (see section: Cleaning the filters). Clean out sink outlet. Filters in the base of the washing compartment are blocked. Water inflow hose has not been correctly positioned. The programme indicator for The sink outlet is blocked. [. . . ] Box 10 83 Tel. : 5322463 Fax: 5242114 Lebanon Adib & Assaferi P. O. Box 539 Tripoli Namibia AEG NAMIBIA (PTY) LIMITED-Jeppe Street Northern Industrial Area Windhoek Tel. : (061) 21-6082/4 Fax: (061) 217838 New Zealand Euro-Life New Zealand Ltd. Privat Bag 58 Symonds Street Auckland Tel. : (09) 525 2222 Nouvelle Caledonie Socometra N. C. 483 Nouman Tel. : 275444 Oman Moshin Haider Darwish P. O. [. . . ]