User manual AEG-ELECTROLUX FAV40730W

[. . . ] FAVORIT 40730 Dishwasher User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Operating Instructions. [. . . ] Open the door and remove the lower basket. Turn the handle about ¼ of a turn anticlockwise (A) and remove the filter system (B). 3. Grasp the grip hole on the fine filter (1) and remove it from the micro-filter (2). Clean all filters thoroughly under running water. 22 1 5. Remove the flat filter (3) from the base of the washing compartment and clean both surfaces thoroughly. Place the fine filter in the micro-filter and fit the two together. Insert the filter system in place and lock it by turning the handle clockwise as far as it will go. Ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without its filters. Cleaning the spray arm jets Regularly check the jets in the spray arms for blockages. When cleaning is necessary, remove spray arm from the fixture and clean jets with a pointed object (wire or needle). Then rinse out the spray arm using a strong jet of water. Do not damage the jet opening. 3 Upper basket spray arm 1. To remove upper basket spray arm, tilt it down hard. Place cleaned upper basket spray arm back in position against the connecting piece: press the two together firmly, until you feel them snap into place. Bottom spray arm 1. To remove bottom spray arm, pull it upwards out of its catch. Place bottom spray arm back in position against connecting piece and press down firmly, until you feel it snap into place. 24 What to do if. . . Remedying small malfunctions If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault. After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. In the case of other fault messages: ­ Cancel the dishwashing cycle. ­ Switch the appliance off and on again. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault message. Malfunction Possible cause The tap is blocked or furred with lime-scale. The programme indicator for the selected dishwashing cycle is flashing, the indicator for the end of the dishwashing cycle is flashing in rhythm 1 short light signal with approx. 3 second pause in-between: (Problems with water inlet) Remedy Clean tap. [. . . ] Service: 021 / 312 27 67 / 8 Poland Electrolux Poland Sp. Domaniewska 41 02-034 Warszawa tel. : 022 874 33 33 fax: 022 874 33 00 Russia Electrolux Russia Ltd. 16 Olympiysky prospekt 129090 Moscow Tel. : (095) 937 7837 Fax: (095) 926 5513 Bulgaria Electrolux Bulgaria E. O. O. D. 2 980 5276 Cyprus Hadjikyrlakos & Sons Ltd. [. . . ]