User manual AEG-ELECTROLUX FAV40S

[. . . ] FAVORIT 40 Dishwasher User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 3 Your dishwasher is fitted with the new "PULSE WASH" dishwashing system. [. . . ] Cancelling the time delay: Press the Delay Timer button repeatedly until the length of the selected cycle appears in the multi-display. The selected dishwashing cycle will begin immediately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. 20 Switching off the dishwasher Do not switch off the dishwasher until the multi-display indicates "0" for the remaining cycle time. With some dishwashing cycles, the drying fan continues to run even after the end of the cycle. Therefore leave the dishes to cool for about 15 minutes before removing them. You also get a better drying result. 1 Removing the dishes 3 It is normal for the inner door and the dispensers to be damp. · Empty the lower basket first, then the upper basket. This way you avoid dripping water from the upper basket onto dishes in the lower basket. Care and cleaning 1 Do not use furniture care products or aggressive cleaners. · When necessary, clean the dishwasher's controls with a soft cloth and clean warm water. · Occasionally check the internal dispensers, door seal and water inlet filter (if fitted) for dirt and clean them, if necessary. 21 Cleaning the filters 3 The filters must be regularly checked and cleaned. Dirty filters will spoil the wash results. Open the door and remove the lower basket. Turn the handle about ¼ of a turn anticlockwise (A) and remove the filter system (B). 3. Grasp the grip hole on the fine filter (1) and remove it from the micro-filter (2). Clean all filters thoroughly under running water. 1 5. Remove the flat filter (3) from the base of the washing compartment and clean both surfaces thoroughly. Place the fine filter in the micro-filter and fit the two together. Insert the filter system in place and lock it by turning the handle clockwise as far as it will go. Ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without its filters. 22 What to do if. . . Remedying small malfunctions If one of the following fault codes is displayed in the multi-display during operation: ­ Fault codeÅ 10 (Problems with water inlet), ­ Fault codeÅ 20 (Problems with water drainage), please have a look at the following table. When the fault is remedied, press the button for the cycle that has started. [. . . ] The guarantee does not apply to defects due to transport which have occurred outside of our responsibility. Nor will the guarantee cover those caused by inadequate installation or assembly, lack of maintenance or failure to respect the assembly instructions or directions for use. Defects that result from repairs or measures carried out by people who are not qualified or expert or defects that result from the addition of non-original accessories or spare parts are not covered by the guarantee. Appliances that are easy to transport may be delivered or sent to the consumer services department. [. . . ]