User manual AEG-ELECTROLUX FAV448

[. . . ] 5 5 7 7 Prior to using for the first time . Adjusting the height of the upper basket. Selecting the dishwashing cycle (Cycle Table) . 15 15 18 19 21 22 24 25 26 Care and cleaning . [. . . ] The selected dishwashing cycle will begin immediately. To change a dishwashing cycle As long as the cycle has not yet started, you can still change the dishwashing cycle. First abort the dishwashing cycle, then re-set the time delay, lastly select the new dishwashing cycle. 25 Switching off the dishwasher Do not switch off the dishwasher until the indicator for the end of the dishwasher cycle is illuminated in the cycle progress display. Therefore leave the dishes to cool for about 15 minutes before removing them. You also get a better drying result. 1 Removing the dishes 3 It is normal for the inner door and the dispensers to be damp. · Empty the lower basket first, then the upper basket. This way you avoid dripping water from the upper basket onto dishes in the lower basket. 26 Care and cleaning 1 Do not use furniture care products or aggressive cleaners. · When necessary, clean the dishwasher's controls with a soft cloth and clean warm water. · Occasionally check the internal dispensers, door seal and water inlet filter (if fitted) for dirt and clean them, if necessary. Cleaning the filters 3 The filters must be regularly checked and cleaned. Dirty filters will spoil the wash results. Open the door and remove the lower basket. Cancel the dishwashing cycle (see chapter: Starting a dishwashing cycle), clean filters (see chapter: Cleaning the filters), then start the dishwashing cycle again. Clean out sink outlet. Filters in the base of the washing compartment are blocked. Water inflow hose has not been correctly positioned. The programme indicator for The sink outlet is blocked. the selected dishwashing cycle is flashing, the indicator for the end of Water drain hose has not the dishwashing cycle is been correctly positioned. flashing in rhythm 2 short light signals one after another. Check hose installation. 30 Malfunction Possible cause Remedy Turn off the tap and contact the Customer Care department. the indicator for the end of the dishwashing cycle is The anti-flood system has flashing in rhythm 3 short been triggered. The mains plug is not plugged in. Plug in mains plug. The cycle is not starting. A fuse in the house's wiring Replace fuse. For dishwasher models with If the dishes are to be a delay start timer: washed immediately, A start time has been selectcancel the delay start. The dishwashing compartment is made from rust-free stainless steel. Rust spots in the dishwashing compartment are due to rust particles from external sources (rust particles from water pipes, pans, cutlery, etc. ). Remove such spots with a commercially-available stainless steel cleaning product. Rust spots are visible in the dishwashing compartment. Only wash cutlery, dishes and pans that are suitable for dishwasher use. A whistling noise can be heard when washing dishes. The whistling is not a cause for concern. Decalcify appliance with commercially available agents for cleaning dishwashers. If the noises can still be heard after decalcifying the machine, use a different brand of detergent for washing cutlery and dishes. 31 If the dishwashing results are not satisfactory The dishes are still dirty. [. . . ] 7 54 1 Chausee Street Port Louis Tel. : 25355 Namibia AEG NAMIBIA (PTY) LIMITED-Jeppe Street Northern Industrial Area Windhoek Tel. : (061) 21-6082/4 Fax: (061) 217838 New Zealand Monaco Corporation Ltd. 10 Rothwell Avenue Albany - Auckland 4399 Auckland 1 New Zealand Tel. : 00 64-92 59 11 11 Fax: 00 64-92 59 11 12 Syria WATTAR CO. Box 36109 Mazzeh - Damascus Direct Phone: 00963116132649 Fax: 00963116119537 Iran ARIAN International Development Co. AEG Showroom Shariati, Balatar as Safar Teheran / Iran Phone No. [. . . ]