User manual AEG-ELECTROLUX FAV475 I-M

[. . . ] Useful tips and hints Environmental information 3 Your dishwasher is fitted with the new "PULSE WASH" dishwashing system. With this dishwashing system the motor speed and spray pressure are varied during the dishwashing cycle to achieve better cleaning of the dishes. It is for this reason that the noise level varies during the dishwashing cycle. 2 Contents Operating Instructions. 4 4 5 5 Prior to Using for the First Time. [. . . ] 3) When using this cycle, only load the dishwasher half full. 4) Test programme for Test Institutes 18 14 - 16 17 - 19 9 22 - 24 2x Water (litres) Main wash Final rinse Drying Starting a Dishwashing Cycle 1. Check that the spray arms can turn freely. One or two lights will flash in the programme progress display. The selected cycle will begin after approximately 3 seconds. Interrupting or Cancelling a dishwashing cycle Interrupt a dishwashing cycle that is in progress if it is absolutely necessary. 1 Interrupting the dishwashing programme by opening the dishwasher door Hot steam may escape when the door is opened. Press function buttons 2 and 3 and keep them pressed. The programme display for the current cycle will flash for several seconds and then go out. The dishwashing cycle has been cancelled. If you want to start a new cycle, check whether there is any detergent in the dispenser. Turning off the dishwasher will only interrupt a selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. 3 Setting the Delay Timer Using the delay timer you can delay the start of a dishwashing cycle for 3, 6 or 9 hours. Insert the filter system in place and lock it by turning the handle clockwise as far as it will go. Ensure that the flat filter does not protrude above the base of the washing compartment. Under no circumstances may the dishwasher be used without its filters. What to do if. . . Remedying small malfunctions If while the appliance is operating indicators on the control panel flash or are lit up as described in the following table, please consult this to find out how to remedy the fault. After remedying the fault that is flashing in the first or second rhythm in the programme progress display, press the button for the dishwashing cycle that had already started. If the fault is displayed again or if other faults are displayed, please contact your local Service Force Centre and inform them of the fault display. 22 Malfunction Possible cause The tap is blocked or furred with lime-scale. The tap is turned off. Remedy Clean tap. Turn the tap on. The programme indicator for the selected dishwashing cycle is flashing, the indicator for the end of the dishwashing cycle is flashing in sequence 1 short light signal with approx. 3 second pause in-between: (Problems with water inlet) The filter (where present) in Clean the filter in the the threaded hose fitting on threaded hose fitting. Press the button for the dishwashing cycle that has started; then cancel the dishwashing cycle (see section: Starting a dishwashing cycle); clean filters (see section: Cleaning the filters). Clean the sink spigot outlet. Filters in the base of the washing compartment are blocked. Water inlet hose has not been correctly positioned. The programme indicator for the selected dishwashing cycle is flashing, the indicator for the end of the dishwashing cycle is flashing in sequence 2 short light signals one after another. [. . . ] · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. · This guarantee is in addition to your statutory and other legal rights. [. . . ]