User manual AEG-ELECTROLUX FAV485W

[. . . ] The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance. It is imperative that these instructions are observed. This symbol or numbered instruction steps lead you step by step through the operation of the appliance. Next to this symbol you receive additional information and practical tips on using the appliance. [. . . ] Place the cutlery basket on a firm support (table, worktop) and unfold both handle parts. After unloading, fold back both handle parts. UI25 UI20 Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. 19 The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates up to 24 cm in diameter), salad bowls, cups and glasses; these should be arranged as shown in the pictures. Glasses with long stems can be placed upside-down in the raised cup-racks. The cup-rack on the left folds upwards to increase your loading flexibility. Arrange items on and underneath the fold-down cup racks so that water can reach all surfaces. Light items (plastic bowls etc. ) should be loaded in the upper basket and arranged so they do not move. US60 Before closing the door, ensure that the spray arms can rotate freely. 20 Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. RC01 A Attention!Due to the shortness of this programme, no drying phase is provided. 24 Approximate values ** Cycle description Hot prewash Main wash up to 70°C 2 cold rinses 1 hot rinse Turbo drying Warm prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Turbo drying Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Turbo drying Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Turbo drying Main wash up to 50°C 1 cold rinse 1 hot rinse 1 cold rinse (to avoid food scraps from sticking to the dishes). Programme duration in minutes Energy consumption in kWh Water consumption in litres 105 - 115 1, 4 18 90 - 100 1, 2 15 90 - 100 1, 1 15 135 - 145 0, 8 14 35 - 45 0, 7 11 10 0, 1 8 ** The times and consumption values are intended as a guide, and depend on the pressure and temperature of the water and also by the variations of the power supply. 25 Operating instructions 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 2. Press the ON/OFF push button The ON/OFF indicator light will illuminate and three horizontal lines (- - - ) will appear in the digital display. 3. Check that there is rinse aid and salt The corresponding indicator lights will illuminate if refilling is necessary. 4. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. 5. 6. Ensure that the spray arms can rotate freely. Add the detergent As all detergents are not the same, you should also consult the instructions on the packet. Close the detergent dispenser lid. 7. 26 Open the water tap The setting of the programme may occur: With open door, in this case the selected programme and eventual options (small load and/or delay start) will start automatically 5 seconds after the closure of the door. With closed door, in this case the selected programme and eventual options (small load and/or delay start) will start automatically 5 seconds after the last pressure of a push button. 8a. Set and start the programme without "DELAY START" q Select the wash programme by simply pressing one of the programme push buttons, the display will show the running time of the programme in minutes and the indicator lights of the phases corresponding to the programme will illuminate. If necessary select the "SMALL LOAD" by pressing the corresponding push button (in this case the running time of the programme will be adjusted). [. . . ] Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter "E" or the earth symbol or coloured green and yellow. Connect the Blue (neutral) wire to the terminal in the plug which is marked with the letter "N" or coloured black. Connect the Brown (live) wire to the terminal in the plug which is marked with the letter "L" or coloured red. CE03 43 The plug moulded onto the lead incorporates a 13amp BSI362 fuse. The plug must not be used if the fuse cover/carrier is lost. [. . . ]